Abstract:Cavitation is an important issue in pumps and usually starts on the blade leading-edge. For fixed blades with constant rotational speeds and specific flow rates, the incident angle, which is between the flow direction and the blade installing direction, on the blade leading-edge plays the key role in the cavitation process. The leading-edge shape is crucial on the local flow separation, pressure distribution, and cavitation. Hence, the influence of the leading-edge shape on cavitation has been studied in the current work in a centrifugal pump impeller. The blunt, sharp, ellipse and round leading-edge cases were compared using numerical simulation and verified by experimental data. Results show different features of cavitation. The round and ellipse leading-edge impellers have higher inception cavitation coefficient. It was caused by the sudden pressure drop on leading-edge arc or elliptical arc. The sharp and blunt leading-edge impellers have a wide flow-separation region on leading-edge with a wide low-pressure region. This is because of the sudden turn in geometry on the leading-edge corner. Cavitation grew quickly after inception and caused rapid head-drop in the sharp and blunt leading-edge impellers. Results suggest the critical cavitation performance is dominated by the leading-edge low-pressure area while the inception cavitation is mostly affected by the minimum pressure value on the leading-edge. The critical cavitation performance can be evaluated by checking the leading-edge low-pressure area. The inception cavitation can be evaluated by checking the minimum pressure value on the leading-edge. These strategies can be used in the further leading-edge designs.

Cavitating Flow Investigation Inside Centrifugal Impellers For A Condensate Pump

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

Numerical Investigation on Cavitation Performance for Centrifugal Pumps with Different Impeller Inlet Geometry

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Influence of Blade Angle Distribution along Leading Edge on Cavitation Performance of a Centrifugal Pump

Numerical Simulation of Flow in Centrifugal Pump with Complex Impeller

Numerical Simulation of Inner Flow Field in Centrifugal Impeller with Long, Middle and Short Blades

Cavitation Performance Evaluation for a Condensate Pump

Numerical Simulation of Inner Flow in Equal-pitch Inducer

Influence of Blade Leading-Edge Shape on Cavitation in a Centrifugal Pump Impeller

Cavitating Flow Analysis and Design Optimization for a Waterjet Mixed Flow Pump

Effect of Impeller Inlet Geometry on Centrifugal Pump Cavitation Performance

Research on Cavitation Characteristic of Inducer

Experimental and numerical investigations of cavitation evolution in a high-speed centrifugal pump with inducer

Cavitating flow investigation in low specific speed axial flow waterjet pumps

Cavitation in a shaft-less double suction centrifugal miniature pump

Experiment and Numerical Simulation of Cavitation Performance for a Double Suction Centrifugal Pump

Visual experiment and numerical simulation of cavitation instability in a high-speed inducer

Experiment and Numerical Simulation of Cavitation Performance for Centrifugal Pump with Inlet Guide Vane

Numerical investigation of cavitating flows in bulb tubular pump and its performance prediction

Liquid-vapor two-phase flow in centrifugal pump: Cavitation, mass transfer, and impeller structure optimization