Abstract:High average power, all-fiber integrated, broadband supercontinuum (SC) sources are demonstrated. Architecture for SC generation using amplified picosecond/nanosecond laser diode (LD) pulses followed by modulation instability (MI) induced pulse breakup is presented and used to demonstrate SC sources from the mid-IR to the visible wavelengths. In addition to the simplicity in implementation, this architecture allows scaling up of the SC average power by increasing the pulse repetition rate and the corresponding pump power, while keeping the peak power, and, hence, the spectral extent approximately constant. Using this process, we demonstrate >10W in a mid-IR SC extending from ∼0.8 to 4μm, >5W in a near IR SC extending from ∼0.8 to 2.8μm, and >0.7W in a visible SC extending from ∼0.45 to 1.2μm. SC modulation capability is also demonstrated in a mid-IR SC laser with ∼3.9W in an SC extending from ∼0.8 to 4.3μm. The entire system and SC output in this case is modulated by a 500Hz square wave at 50% duty cycle without any external chopping or modulation. We also explore the use of thulium doped fiber amplifier (TDFA) stages for mid-IR SC generation. In addition to the higher pump to signal conversion efficiency demonstrated in TDFAs compared to erbium/ytterbium doped fiber amplifier (EYFA), the shifting of the SC pump from ∼1.5 to ∼2μm is pursued with an attempt to generate a longer extending SC into the mid-IR. We demonstrate ∼2.5 times higher optical conversion efficiency from pump to SC generation in wavelengths beyond 3.8μm in the TDFA versus the EYFA based SC systems. The TDFA SC spectrum extends from ∼1.9 to 4.5μm with ∼2.6W at 50% modulation with a 250 Hz square wave. A variety of applications in defense, health care and metrology are also demonstrated using the SC laser systems presented in this paper.

High-power Wavelength-Tunable Thulium-Doped All-Fiber Superfluorescent Source

High-power single-stage thulium-doped superfluorescent fiber source

High-power all-fiber superfluorescent source with fused angle-polished side-pumping configuration.

Widely-tunable All-Fiber Tm Doped MOPA with >1 Kw of Output Power

Widely-tunable all-fiber Tm doped MOPA with > 1 kW of output power

Watts-Level Super-Compact Narrow-Linewidth Tm-Doped Silica All-Fiber Laser Near 1707 Nm with Fiber Bragg Gratings

714 W all-fiber supercontinuum generation from an ytterbium-doped fiber amplifier

2Μm Femtosecond Fiber Laser Source and Its Application for Mid-Ir Supercontinuum Generation

3 W Narrow-Linewidth Ultra-Short Wavelength Operation Near 1707 Nm in Thulium-Doped Silica Fiber Laser with Bidirectional Pumping

Kilowatt-Level High-Efficiency Narrow-Linewidth All-Fiber Tm3+-Doped Laser

Ultra-short Wavelength Operation in Thulium-doped Silica Fiber Laser with Bidirectional Pumping

Low noise, self-phase-modulation-enabled femtosecond fiber sources tunable in 740-1236 nm for wide two-photon fluorescence microscopy applications

1535–1620 Nm Widely Tunable Watt-Level Single-Mode Er:Yb Codoped All-Fiber MOPA

Stable Gain-Switched Thulium Fiber Laser with 140 Nm Tuning Range

Near-infrared supercontinuum generation in an all-normal dispersion MOPA configuration above one hundred watts

High power all fiber mid-IR supercontinuum generation in a ZBLAN fiber pumped by a 2 μm MOPA system

Modulation instability initiated high power all-fiber supercontinuum lasers and their applications

High-power and high-speed all-optical all-fiber wavelength-swept source at 2 μm based on a femtosecond laser and time stretch technique

High-power Lasing at 900 Nm in Nd3+-doped Fiber: a Direct Coordination Engineering Approach to Enhance Fluorescence

700 W single-frequency all-fiber amplifier at 1064 nm with kHz-level spectral linewidth

Self-phase modulation enabled, wavelength-tunable ultrafast fiber laser sources: an energy scalable approach.