Abstract:Water holdup in crude oil-water flows is a crucial parameter to identify flow patterns or monitor the flow process in oil production. It has been increasingly important to accurately predict water holdup. Due to the simple structure and robust performance, capacitance probes have been widely used in experimental research and industrial application. In this paper, we proposed a water holdup measurement device based on a capacitance probe for crude oil-water flows. The measurement principle lies in the fact that the output capacitance is proportional to the part of the probe immersed in water. It was found that when inserted into crude oil, the surface of the probes will absorb hydrocarbons and form an oil film covering the probes. The formed oil film will reduce the sensitivity of the output capacitance to the water layer height. The thicker the film the lower the sensitivity. We examined the parameters that affect the thickness of the formed oil film and found that the thickness is mainly dependent on temperature and water holdup. The higher the temperature the thinner the formed oil film. The reason is that an increase of temperature leads to a decrease of viscosity. In addition, as the temperature approached about 50 °C, the thickness is nearly unchanged. As for the water holdup, at low temperatures the effect is considerable. At relatively high temperatures, the effect is minor and can be neglected. The experimental results showed that the capacitance probes have the highest sensitivity at about 50 °C. We designed and manufactured a prototype of the measurement device. The probes were inserted with heating wires to heat the crude oil near the probes and the current was controlled by an integrated circuit to maintain the temperature at about 50 °C. The field test showed that the natural gas entrained in the production fluids caused the device to under-predict the water holdup. After gas-liquid separation, the prediction errors were within ±6%.

Water Layer Height Measurement in Oil-Water Two-Phase Flows

Water holdup measurement in kerosene–water two-phase flows

Equivalent water layer height (EWLH) measurement by a single-wire capacitance probe in gas–liquid flows

Study on Performance of Double Helical Capacitance Probe for Water Fraction Measurement in Multiphase Flow

The Finite Element Analysis for a Mini-Conductance Probe in Horizontal Oil-Water Two-Phase Flow

A C~4D-Based Measurement System of Gas-Liquid Two-Phase Flow

A new method for the velocity measurement of gas-liquid two-phase flow

Capacitance Probe for Water Holdup Measurement in Crude Oil-Water Flows

A New Method for Flow Rate Measurement in Millimeter-Scale Pipes.

Measurement of Water Holdup in Vertical Upward Oil–Water Two-Phase Flow Pipes Using a Helical Capacitance Sensor

Measurement of Bubble Velocity Using Capacitively Coupled Contactless Conductivity Detection (C4D) Technique

Oil-water two-phase flow velocity measurement with Continuous wave ultrasonic Doppler

Oil-water two-phase flow measurement based on differential pressure

Measurement of Interfacial Area Transport in Oil-Water Dispersed Flow by Double-Sensor Probe

A Novel Method for Holdup Measurement of Three Phases by an Ultrasonic Device with the Flexible Substrate

Cross-correlation Velocity Measurement of Horizontal Oil–water Two-Phase Flow by Using Parallel–wire Capacitance Probe

Comparison Between 180° and 360° Double Helix Capacitance Sensors for Measuring Water Holdup of Horizontal Oil–Water Stratified Flows

Investigation of Oil-Air Two-Phase Mass Flow Rate Measurement Using Venturi and Void Fraction Sensor

Flow Pattern Identification Based on A Single-Wire Capacitance Probe

An Experimental Study of On-Line Measurement of Water Fraction in Gas-Oil-water Three-Phase Flow

Horizontal Air-Water Two-Phase Flow Measurement Using an Electrical Impedance Probe and a Venturi Flow Meter