Abstract:The unloading and reloading of geostress during the excavation of large underground caverns tends to bring about large deformation and failure problems of rock masses with interlayer staggered zones (ISZs), posing significant threats to the safety and stability of the underground cavern. Hence, for interlayer staggered zones with complex mechanical response behaviors, a series of conventional triaxial cyclic loading tests under different confining pressures were carried out. It can be seen from these results that the envelop curves of stress–strain relations were of obvious memory, but the peak deviator stress, internal friction angle, and cohesion were lower than those in monotonic loading. The phenomenon of volume expansion occurred in the whole process of cyclic loading and unloading, and the unloading dilatation seemed to be more sensitive to relatively low confining pressure. The volume expansion reached its highest value when the unloading stress level (i.e., the ratio of the stress ratio in the process of the cyclic test to the stress ratio when the ISZ comes to the failure point) increased to more or less 0.6∼0.8. Moreover, the changing trend of the average rebound modulus was humplike with the increase of unloading stress level, and the ratio of average rebound modulus to monotonic initial elastic modulus declined as a power function. Additionally, the validity of the unloading rebound modulus calculation by the Duncan-Chang model is proved. The analysis of energy consumption in plastic hysteresis loops indicates that the plastic hysteresis energy of the specimen in each cycle rose with the stress level’s increase. Further microscopic failure mechanism analysis shows that the previous research results are synthetically affected by factors including particle motion and breakage, initiation and propagation of original and new fractures, yield, and damage of interlayer staggered zones. This research provides a theoretical premise for exploring the cyclic unloading and reloading stress path influence on the failure of surrounding rock with ISZs, as well as for more reasonable mechanical parameter selection in deep underground excavations.

Laboratory Investigation on Slip Behaviors of Fault Induced by Cyclic Confining Pressure

Advanced laboratory investigation of axial cyclic loading in silica sands

Two sides of a fault: Grain-scale analysis of pore pressure control on fault slip

Experimental study on the characteristics of fault stick–slip behavior under different normal stresses

Laboratory Simulation of Injection-Induced Shear Slip on Saw-Cut Sandstone Fractures under Different Boundary Conditions

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

Unloading-induced Instability of a Simulated Granular Fault and Implications for Excavation-Induced Seismicity

On the Unloading‐Induced Fault Reactivation: The Effect of Stress Path on Failure Criterion and Rupture Dynamics

Investigation on acoustic emission characteristics of fault stick-slip under different lateral pressures

Sliding modes of fault activation under constant normal stiffness conditions

Experimental Study of Mechanical Behavior of Interlayer Staggered Zone under Cyclic Loading and Unloading Condition

Experimental evidence for multiple controls on fault stability and rupture dynamics

Analysis of Near-Field Stresses in an Analogue Strike-Slip Fault Model

Effect of unloading rate of normal stress on the frictional slip behaviour of fractured rocks

Experimental Investigation and Analysis of Triggering Mechanism for Fault-Slip Bursts of the Tunnel Surrounding Rock with External Disturbance

Slip characteristics of planar and rough granite fractures under unloading normal force

Experimental study on the dynamic displacement evolution of fault in stick-slip process

The effect of shear displacement and wear on fault stability: Laboratory constraints

Intermittent Criticality Multi‐Scale Processes Leading to Large Slip Events on Rough Laboratory Faults

Laboratory observations of frictional stability and fault zone evolution under heterogeneous friction, rheology, and stress conditions

Influence of Fault Dip Angle and Strength on Fault Slip Characteristics of Gas Storage