Abstract:The tunnel entrance is usually made of arch members buried at shallow depths. These contribute to the greater performance of the tunnel under static or seismic loading. If an explosion occurs in the shallow buried tunnel, the tunnel arch at the entrance might be destroyed by the intense blast loading, thereby causing the collapse of the tunnel entrance or the surrounding ground. Hence, it is extremely important to investigate the dynamic behavior of a shallow buried tunnel arch under the conditions of an internal explosion and to evaluate its damage after the blast. In this paper, four scaled tunnel arch structures were fabricated and tested for their anti-blast performance under internal explosion. The following laboratory static load test was conducted on the undamaged and blast-damaged specimens to obtain their maximum and residual bearing capacities, respectively. The field blast test results showed that the tunnel arch experienced local punching failure under the internal contact explosion, and the dimensions of the failure zone increased as the explosive equivalent increased. In addition, for the same explosive equivalent, the residual bearing capacity of the specimen after the contact explosion at the arch crown was the lowest among other blast-damaged specimens, indicating that the damage on the arch crown significantly deteriorated the bearing capacity and stiffness of the tunnel arch. The finite element (FE) model of the shallow buried tunnel arch under the internal explosion was developed by adopting the arbitrary Lagrangian–Eulerian (ALE) algorithm in LS-DYNA and validated on the actual measurements from the field blast test. It is shown that the results from the FE model and field blast test measurements compared well in terms of damage pattern, crater diameter, acceleration and reflected overpressure readings. The full restart method in LS-DYNA was further employed to calculate the bearing capacity of the specimens. Finally, the damage levels of the blast-damaged specimens were assessed by taking the residual bearing capacity of the tunnel arch as an indicator. The damage assessment charts for the shallow buried tunnel arch under the conditions of an internal explosion were further established. From the chart, the blast resistance of the shallow buried tunnel arch can be quickly assessed under different internal blast loading conditions. This research is of direct significance for the design of the shallow buried structures with increased blast resistance.

Explosion Behaviors of Scaled Shallow-Buried Concrete–Rubber-Laminated Annular Metastructures: Evaluation of Shock Wave Attenuation

Close-in Explosion Behaviors of Scaled Concrete–rubber Layered Circular Meta-Tunnels

Impact Analysis and Absorber Design for Collision Protection of Part-Buried Structures

Anti-explosion Tests and Numerical Simulations of Ultra-High Toughness Cementitious Composites Subjected to Blast by Embedded Explosives

Composite Wave Attenuation Mechanism of Periodic Layered Metastructure with Embedded Rubber-Mass Resonators

Model test of deep buried underground structure under ground shock induced by explosion

Experimental study of deep-burial underground structures subjected to multiple 45 side-top far-field explosions

Vibration Attenuation of Finite-Size Metaconcrete: Mechanism, Prediction and Verification

Damage Mechanism Of Reinforced Concrete Slab Under Internal Blast Loading

Damping, Wave Attenuation and Damage of Local-Resonance-based Metaconcrete Slabs: Experimental Investigation

Investigation on Anti-Explosion Performance of Reinforced Concrete Slab with Composite Protective Aluminum Foam

Evaluation of anti-explosion performance of Shuibuya concrete-faced rockfill dam slabs subjected to strong shock waves caused by an underwater explosion

Centrifugal model tests on impact of environmental vibration on scientific device-housed tunnel and vibration reduction schemes

Experimental investigation on the anti-detonation performance of composite structure containing foam geopolymer backfill material

Experiment and Numerical Investigations of Ultra-High Toughness Cementitious Composite Slabs under Contact Explosions

Explosion Vibration Mitigation of Meta-Plate with Mass–spring Metastructures

Experimental study on the elastic-plastic dynamic response of shallow-buried corrugated steel-plain concrete composite structures under long-duration plane blast wave loading

Dynamic performance and damage assessment of a shallow buried tunnel under internal explosion

Study on the Earth-Covered Magazine Models under the Internal Explosion

Layered metastructure containing freely-designed local resonators for wave attenuation

Experimental and Numerical Investigations on Ultra-High Toughness Cementitious Composite Slabs Subjected to Close-in Blast Loadings