Abstract:With the trend of higher power density, miniaturization as well as higher operating temperature requirement, heat transfer problem has been one of the crucial issues. Microchannel heat sink shows a great potential regarding to the excellent heat dissipation capacity. This paper aims to design microchannel heat sink for high power modules cooling based on topology optimization method to obtain better cooling performance which is more compact with less mass, less frictional losses and increased thermal efficiency. To reduce the number of degrees of freedom, only the temperature magnitude and uniformity are focused. Commercial finite element software COMSOL combined with secondary development by MATLAB is used in the topology optimization analysis for 2D model of heat sink. Heat flux density 300 W/cm 2 is loaded on the whole plate sized 50*50 mm 2 uniformly. Density approach is imported to describe the volume force term of fluid and solid. Minimize pressure drop combined with maximize heat dissipation is set as the objective functional for the optimization. Finite element model based on topology optimization method is established and analyzed. It could be found that the microchannel heat sink was effective to cool down the temperature under 125 °C, and through topology optimization method the maximum temperature could be reduced to 106 °C, and the temperature difference of the whole plate is 14.4 °C, which satisfied the multi-physics and multiple optimization objectives requirements. Besides, the calculation results also showed that the weighting factor ratio of pressure drop to heat dissipation could influence the topology structure and heat dissipation ability of heat sink.

Simulation of Thermal Distribution in SiC Power Modules with Pinfin Heatsink Based on Lattice Boltzmann Method

Nature Convection Heatsink Modeling and Optimization Based on Nusselt Number Correlation

Analytical Modeling of Forced-Air Cooling Heatsink by Considering Air Temperature Rise in Channel and Coupling of Multiple Heat Sources

Thermal-Fluid Co-Simulation and Modelling of IGBT with Thermal Resistance Network

An Experimental Study of Microchannel and Micro-Pin-Fin Based On-Chip Cooling Systems with Silicon-to-Silicon Direct Bonding.

Electrical-Thermal Co-Simulation For Through Silicon Via And Active Tier In 3-D Ic

System-Level Analysis of 3D ICs with Thermal TSVs

Comprehensive Thermal Resistance Model of Forced Air Cooling System for Multiple Power Chips

Coupled Electrical-Thermal-Fluidic Multi-Physics Analysis Of TSV Pin Fin Microchannel In The 3D-Ic

Research on thermal performance and optimization design of phase change pin fin heat sink based on Lattice Boltzmann method

A Full Chip Scale Numerical Simulation Method for Thermal Management of 3D IC

Numerical simulation of a heat sink embedded with a vapor chamber and calculation of effective thermal conductivity of a vapor chamber

Three-dimensional Lattice Boltzmann study on structure optimization and heat dissipation performance of pin-fin heat sink integrated with phase change material

Development of a steady state electrothermal cosimulation model of SiC power modules

Multi-scale simulation and optimization on a thermal management system of intermediate circuit and experiment validation

Double-sided heat dissipation numerical modeling of an embedded half-bridge power module with multiple chips

Modeling and Simulation of Power Electronic Modules with Microchannel Coolers for Thermo-Mechanical Performance

Design of Microchannel Heat Sink Using Topology Optimization for High Power Modules Cooling

ATSim3D: Towards Accurate Thermal Simulator for Heterogeneous 3D-IC Systems Considering Nonlinear Leakage and Conductivity

Double-sided numerical thermal modeling of fan-out panel-level MOSFET power modules

Numerical and experimental investigation of optimized heat sink designs for liquid cooling of a heterogeneous heating surface with multiple heat sources