Abstract:When the working frequencies of vacuum electronic devices reach the terahertz frequency (0.1-10 THz), the Ohmic loss has a great impact on the vacuum electronic devices. To study the effect of the Ohmic loss on the working characteristic of the vacuum electronic devices in the terahertz band, this paper presents the boundary condition of surface impedance used in the 2.5-dimensional fully electromagnetic particle simulation code UNIPIC, which is verified by simulating the terahertz wave in the circular copper waveguide; the simulation result indicates that the code can correctly simulate the propagation of terahertz waves in the waveguide with an Ohmic loss. Then, the coaxial surface wave oscillators (SWO) with slow wave structures (SWS) made of different metals are numerically studied by using the above code, and the dependences of output power on the SWOs with different metal SWSs are analyzed. Numerical results show that the metal conductivity has a considerable effect on the output power of the device: When the conductance of the metal decreases, the quality factor of the device becomes smaller, the start-up time becomes longer, also the output power of the device decreases also. For the coaxial SWOs operating at 0.14 THz, the output powers from the copper and stainless steel SWSs are reduced by 13.4% and 63.9%, the start-up times of the devices are delayed by 0.4 ns and 15 ns, respectively. Meanwhile, the working frequencies of the devices with the SWSs made of different metals keep unchanged.

Ohmic Losses in Coaxial Resonators with Longitudinal Inner-Outer Corrugation

Research of Coupling Coefficient Extraction of a Cavity Resonator

Lossy effects on the transient propagation in LTCC coplanar waveguides (CPWs)

COMPARATIVE STUDY ON THE INTERACTION OF ELECTROMAGNETIC WAVES WITH MULTI-LAYER OMEGA(CHIRO)FERRITE SLABS

A Study on Characteristics of Coaxial Resonant Cavity with Bent Inner Conductor

Effect of Ohmic Loss on Coaxial Surface Wave Oscillator in Terahertz Band

Coupling Losses and Mode Properties in Annular Waveguide Laser Resonator

High-Order Mode-Matching-Based Single-Cavity Coaxial Transducer for Broadband Measurement of Complex Permittivity

Measurements of excess loss of the crossed waveguide using optical waveguide ring resonators

An Equivalent Cross-Section Model for CORC Cable to Achieve Accurate AC Loss Estimations

Experimental Investigation of R(ω), T(ω) and L(ω) for Multi-Layer SRRs and Wires Metamaterials

Numerical analysis of high frequency characteristics of coaxial relativistic backward wave oscillator

Numerical Investigation of the Coupling Effect in CORC Cable with Striated Strands

Determining interface dielectric losses in superconducting coplanar waveguide resonators

Analysis of Ohmic Loss Due to Non-Ideal Boundary in Relativistic Backward Wave Oscillator

Effects of the Coated Lossy Layer on the Propagation Characteristic of Electromagnetic Wave in a Metal Cylindrical Waveguide

Studies Of A Two-Dimensional Coaxial Bragg Structure With Double Helically Corrugated Surfaces

Analysis of the Characteristics of a Coaxial Gyrotron Cavity with a Tilted Inner Rod

Parametric modelling of the lossy folded waveguide circuits for the 220 GHz backward wave oscillator

Optimize and Design of Coupling Antenna for TM021 Resonant Cavity

Starting Current of Coaxial Relative Backward Wave Oscillator