Abstract:A contactless self-calibration temperature sensor based on the rare-earth fluorescence was developed. The new temperature sensing film Yb@PSMM was prepared by dispersed K[Yb(Az)(4)] in poly (styrene-block-methyl methacrylate) and then attached to a clean quartz plate, and the optical properties of Yb3+ in this system under different temperature were investigated. The shape of the fluorescence emission spectrum of Yb3+ changed regularly with temperature, and the distribution of extra-nuclear electrons in the Stark cleavage sublevels of Yb3+ at different temperatures still obeyed Boltzmann distribution law. The natural logarithm (In) of the ratio of the two characteristic emission peak areas at 900 similar to 990 and 990 similar to 1 150 nm in the fluorescence spectrum linearly varied with the reciprocal of temperature (1/T) from -195 to 105 degrees C. Upon using this linear relation as the standard curve, this temperature sensing method exhibited a temperature resolution of 0. 1 degrees C around 0 . Compared with the reported luminescence temperature sensors, the new temperature sensor proposed in this paper had advantages as follows. Firstly, the Stokes shift of the selected luminescent material was larger than 500 nm, which effectively avoided the interference of environmental backgrounds. Secondly, due to the use of fluorescence integrated peak areas instead of fluorescence intensities, the influence of random errors introduced by the instrument or measurement was greatly reduced. Thirdly, by taking advantage of the radiometric relationship between the intensities of different fluorescence peaks in one compound, a reliable self-calibration was introduced in this system equality, which effectively reduced the influence of external factors such as the variation of fluorescent material concentration, geometric configuration, or light source intensity. Fourthly, as a rare-earth luminescence material, the sensing method could utilize the characteristics of long fluorescence lifetime, good fluorescence monochromaticity, and high fluorescence intensities. Fifthly, the temperature sensing film was almost insoluble and indiffusible in water, which was convenient for direct measurement of the in-situ temperature changes. Lastly, Yb2+ emission was from 900 to 1 150 nm, due to the deep penetration of near infrared light, this temperature sensor would have a wide potential use in temperature-sensing and imaging of complex system. Further ensuring method for the measurement results of the temperature sensor was adopted in our measurement device : the irradiated spot size on the sample could be adjusted to be about 1 mm 2 , and the angle between the placement di- rection of Yb@PSMM film and the excitation light was set to be 225 degrees. Thus, the influence of the reflected light was circumvented, but the fluorescent emission light was hardly affected.

A Reliable Fiber-Optic Temperature Sensor Based on Fluorescence Intensity Ratio Technique for Real-Time Human Thermal Detection

Single Optical Microfiber Enabled Tactile Sensor for Simultaneous Temperature and Pressure Measurement

Fiber temperature sensor based on rare earth fluorescence material

High-sensitivity Ratiometric Thermometers of Yb 3+/er 3+/tm 3+Co-Doped LuScO 3 Single Crystal Fibers Based on Non-Thermally Coupled Energy Levels

Yb,Er,Tm:Sc2O3 Single Crystal Fibers for Multi-Mode Optical Thermometry

High-sensitivity Ratiometric Thermometers of Yb3+/Er3+/Tm3+ Co-Doped LuScO3 Single Crystal Fibers Based on Non-Thermally Coupled Energy Levels

Sapphire-Fiber Thermometer Ranging from 20 to 1800 °C

Optical Fiber Sensor with Double Tubes for Accurate Strain and Temperature Measurement under High Temperature Up to 1000 °C

A temperature sensor based on Er3+/Yb3+ co-doped tellurite fiber for real-time thermal monitoring of transformers

Integrated Multi-Mode Glass Ceramic Fiber for High-Resolution Temperature Sensing

A Simple and Low-Cost Fiber-Optic Sensor Based on Photoluminescence for Temperature Independent Ultraviolet Detection

Fluorescence Fiber Optic Temperature Sensor Based On Fused Upconversion Luminescent Nanoparticles

A Simple, Compact, Low-Cost, Highly Efficient Thermometer Based on Green Fluorescence of Er3+/Yb3+-codoped NaYF4 Microcrystals.

Preparation and Performance of a Fiber Optic Temperature Sensor with Multiple Fluorescence Mechanisms

High-sensitivity and Fast-Response Fiber Optic Temperature Sensor Using an Anti-Resonant Reflecting Optical Waveguide Mechanism

A Contactless Self-Calibration Temperature Sensor Based on the Rare-Earth Fluorescence

Manipulable Multipurpose Nanothermometers Based on a Fluorescent Hybrid Glass Fiber Microsphere Cavity

An optical fiber temperature sensor based on fluorescence intensity ratio in Er3+/Yb3+ co-doped Gd2O3 phosphors

An Optical Temperature Sensor Based on the Upconversion Luminescence from Tm3+/Yb3+ Codoped Oxyfluoride Glass Ceramic

Eye-Resolvable Surface-Plasmon-Enhanced Fluorescence Temperature Sensor

Ratiometric nanothermometer in vivo based on triplet sensitized upconversion