Dual-Polarized Ka-Band Phased Array Using Hybrid Magnetic-/Electric-Dipole with Low Profile for Low Cross-Polarization Leakage inside ±60° Scan Volume
Jian Xu Sun,Yu Jian Cheng
DOI: https://doi.org/10.1109/tap.2023.3256486
IF: 5.7
2023-01-01
IEEE Transactions on Antennas and Propagation
Abstract:This article presents a 26–40 GHz $16 imes16$ dual-polarized phased array. For the dual-polarized phased array antennas, the sources of cross-polarization leakage mainly include the polarization coupling from the feedlines and the radiators. Electric-dipole (E-dipole) and magnetic-dipole (M-dipole) are the most common radiators, which both suffer from the deteriorated polarization isolation when scanning in D-plane. Here, the hybrid M-/E-dipole is employed to overcome this issue. To avoid the serious cross-polarization leakage from the typical 1/4 wavelength feedline of E-dipole, the M-dipole is chosen to form the primary radiator with the typical 1/10 wavelength feedline. Therefore, the excited electric-/magnetic-current field vectors on the radiators and the feedlines can be significantly weakened. However, the low-profile M-dipole introduces the half-patch TM11 mode due to the coupling between the horizontal feedline and the ground plane. This parasitic radiation mode with the slant polarization seriously deteriorates the polarization isolation of the M-dipole. The shorted posts are employed to suppress the half-patch TM11 mode without breaking the M-dipole mode. Through that, the high polarization isolation characteristic of the dual-polarized M-dipole radiator is maintained. Then, the double-layer meta-surface (MS) is designed to act as the secondary radiator, i.e., the E-dipole. The MS also plays the role of the impedance matching layer. Based on these methods, the cross-pol. level better than {−66, −59, −52} dB in E-/H-planes and {−66, −28, −17} dB in D-plane when scanning to {broadside, 30°, 60°} is achieved, respectively.
telecommunications,engineering, electrical & electronic