Abstract:CRUD depositions on fuel cladding are the main cause of power shift and localized corrosion in nuclear power plants. This paper is the third of a three-part study concerning the prediction of CIPS risks during fuel burnup. In this paper, based on the coupling modules of CRUD growth and internal heat and mass transfer in Part 2, a multi- physics coupling method for high-fidelity simulation of CRUD growth and CIPS phenomenon is developed to better understand coupled physics and respective feedback mechanisms. Based on OpenMC, Fluent and self- developed CRUD-related code, this coupling method considers nuclide depletion, coolant flow, heat transfer and water chemistry, in which fine radial CRUD mesh in neutronic module and influences of CRUD surface characteristics on heat transfer in thermal-hydraulic module are introduced. The coupling method is applied to predict CIPS risk during a 360-day cycle depletion process reaching burnup of 22.04 MWd/kgHM. Corrosion products deposit on cladding to thicken CRUD, while flow erosion gets enhanced washing away more particles on CRUD surfaces, resulting in a slow-down net CRUD growth rate, reaching maximum values of 8.60 gin mass and 37.10 mu m in thickness at EOC. As CRUD depositions thicken, boron hideout mass increases, while subsequently bulk coolant boron concentration decreases and boron diffuses out of CRUD depositions causing a decrease in boron hideout mass. The highest boron hideout mass and most negative AO both occur near MOC time. At EOC, net mass reduction of boron hideout and bottom-favored nuclide depletion contribute toward pushing power distribution closer to 0 % axial offset. The results of this study provide a precise method for understanding CIPS risk and its influencing factors to further predict and alleviate CRUD-related safety issues.

An Analysis of Possible Impacts of Power Uprate on the Distributions of Erosion-Corrosion Wear Sites for a BWR Through CFD Simulation

An Analysis of Possible Impacts of Power Uprate on the Distributions of Erosion-Corrosion Wear Sites for a BWR Through CFD Simulation

Cfd Investigating The Changes Of Fac Wear Sites Due To The Power Uprate Of Nuclear Power Plant

Predicting Local Distributions of Erosion–corrosion Wear Sites for the Piping in the Nuclear Power Plant Using CFD Models

CFD investigating the influence of power uprate on impingement wear sites for the feedwater heater in the nuclear power plant

Predicting the Wall Thinning Engendered by Erosion–corrosion Using CFD Methodology

Application of Local Flow Models in Predicting Distributions of Erosion-Corrosion Locations

A Two-Phase Methodology to Predict Fac Wear Sites in the Piping System of A Bwr

Predictions of Hydrodynamic Characteristics and Corrosion Rates Using CFD in the Piping Systems of Pressurized-Water Reactor Power Plant

Predicting Distributions of Wear Sites on Shell Wall of Feedwater Heater in Nuclear Power Plant Using Two Phase Models

Prediction of possible wear sites on the shell wall of feedwater heater due to droplet impingement using CFD models

CFD analysis for full vessel upper plenum in Maanshan Nuclear Power Plant

Numerical study on surface corrosion deposition of fuel elements and its influence on flow heat transfer

Study on coupling effect of CRUD growth and heat transfer on fuel rod

Erosion-corrosion Failure of REAC Pipes under Multiphase Flow

Pressurized Water Reactor Fuel Corrosion-Related Unidentified Deposit and Its Related Safety Issues – III. N-TH-M Coupled CIPS Prediction

Development of CFD Methodology for Investigating Thermal-Hydraulic Characteristics in a PWR Dome

CRUD deposition induced multi-physics effects analysis in PWR

Thermal Hydraulic Investigations and Optimization on the Evc System of A Pwr by Cfd Simulation

Numerical Investigation on the Thermal Stratification in a Pressurizer Surge Line

NUMERICAL STUDY ON THE EROSION CHARACTERISTICS OF U-TYPE BEND FOR GAS SOLID FLOW