Numerical Investigation of H2/air Mixing Characteristics in Micro-Tubes with Different Geometric Configurations
Xiaodong Ren,Yuan Feng,Chunwei Gu
DOI: https://doi.org/10.1063/5.0214358
IF: 4.6
2024-01-01
Physics of Fluids
Abstract:The micro-mixing combustor exhibits the advantages of rapid and uniform mixing of fuel and air, high safety, and low emissions, showing broad prospects in the utilization of hydrogen energy. The micro-tube serves as a fundamental unit of the micro-mixing combustor. This paper places emphasis on the mixing mechanism of hydrogen and air in the micro-tube, conducting a thorough analysis of the mixing phenomena in micro-tubes with different geometric configurations using the large eddy simulation (LES) method. When employing the fuel single-hole vertical injection structure, the micro-tube jet in cross-flow (JICF) generates vortex structures similar to those in open-space JICF. The counter-rotating vortex pair (CVP) plays a crucial role in the mixing process, but its mixing ability in the jet direction is not strong enough, leading to lower fuel concentration near the wall and increased mixing deficiency. At higher fuel injection speeds, the fuel jet impacts the wall and wraps around it, enclosing the air and promoting mixing. Increasing the number of fuel holes to 2, under constant speed ratio, results in a phenomenon of mutually opposing fuel jets, squeezing the fuel to the sides of the micro-tube. This enhances the local near-wall fuel concentration and reduces mixing deficiency. However, when using 3 or 4 fuel holes, the jets no longer oppose due to reduced penetration depth, and poor diffusion of fuel near the wall remains the main reason for mixing deficiency. To improve near-wall fuel concentration, structures with the jet at a certain angle to the diameter are studied. Under the influence of the wall, CVP evolves into a single vortex, and the fuel rotates along the wall. When the jet is inclined at 45 degrees to the diameter, mixing deficiency rapidly decreases. It can achieve relatively ideal mixing effects, with fuel and air uniformly mixed downstream of the fuel hole at approximately 15 times the tube diameter.