Abstract:Since the available ambient power level is usually quite low for radio frequency energy harvesting, it is very desirable for an antenna to have both a high gain and a wide beamwidth. Usually, they cannot be achieved simultaneously. In order to overcome this limitation, a multi-port antenna using a nonuniform metasurface (MTS) is presented. In this MTS-based antenna, three modes with complementary radiation patterns are excited through one middle and two side aperture-coupled feeding ports. The first mode is the fundamental TM10 mode with in-phase current distributions on the MTS. It has a broadside directional radiation pattern with a high gain. The second and third modes are symmetrical to each other at a high mode. They have opposite current distri-butions on two sides of the MTS. These two modes have a directional radiation pattern with a tilted angle. These three modes share the same aperture but are excited by three different feeds. Each feed is connected to a rectifier. By combining direct current (DC) output to a single load, an antenna with a wide beam and a high gain can be effectively achieved, although each mode has the usual limitation of gain and beamwidth. The key advantage of this proposed rectenna is that the unit cells on the MTS layer can be reused to excite different MTS modes with different radiation patterns simultaneously. Thus, a wide beamwidth can be achieved. Three realized beams are oriented at - 35 degrees, 0 degrees, and + 35 degrees respectively. By combining the DC output from the three modes, the proposed rectenna has effectively achieved a beamwidth of 114 degrees with a gain ranging from 8 to 9.8 dBi. The RF-to-DC conversion efficiency of the rectifiers is 3%-67% at 2.45 GHz when the input power ranges from-35 to 0 dBm. The proposed MTS antenna with an overall size of lambda 0 x lambda 0 x 0.03 lambda 0 can achieve 12% fractional bandwidth.

Broadband Energy Harvesting Metasurface Covering WiFi band with Wide-Angle Incidence

Wideband Wide-Angle Polarization-Independent Metasurface for Wireless Power Harvesting

Energy Harvesting Metasurface with Polarization-Independent and Wide-Angle-Incident Performances for 2.45GHz and 5.8GHz

Design of a Rectifying Metasurface for Wireless Energy Harvesting

A Scalable, Wide-Angle Metasurface Array for Electromagnetic Energy Harvesting

A Dual-Band, Polarization-Insensitive, Wide-Angle Metasurface Array for Electromagnetic Energy Harvesting and Wireless Power Transfer

A wide-angle incidence, broadband rectified metasurface for radar frequency band EM energy harvesting and wireless power transfer

Wideband High Efficiency and Simple-Structured Rectifying Metasurface

Metasurface: Enhancing Gain of Antenna and Energy Harvesting System Design

Scalable, Dual-Band Metasurface Array for Electromagnetic Energy Harvesting and Wireless Power Transfer

Tri-band miniaturized wide-angle and polarization-insensitive metasurface for ambient energy harvesting

A multi-frequency and multi-mode metasurface energy harvester for RF energy harvesting

Dual-Band, Wide-Angle, and High-Capture Efficiency Metasurface for Electromagnetic Energy Harvesting

High Efficiency Electromagnetic Energy Harvesting with Metasurface

Polarization-insensitive and wide-angle metasurface to harvest dual-band energy in an ISM band

Aperture Sharing Metasurface-Based Wide-Beam Antenna for Energy Harvesting

Circularly polarized metasurface antenna based on characteristic mode analysis for microwave energy harvesting

Metantenna Design with One‐dimensional Holographic Concept

Rf Energy Harvesting with Broadband Antenna

Designing an efficient rectifying cut-wire metasurface for electromagnetic energy harvesting

Low-Cost Air Gap Metasurface Structure for High Absorption Efficiency Energy Harvesting