Ring‐Opening Polymerization of Propylene Oxide Catalyzed by a Calcium‐Chloride‐Modified Zinc‐Cobalt Double Metal‐Cyanide Complex

Yijun Huang,Xinghong Zhang,Hua Zheng-jiang,Shi‐Liang Chen,Guilin Qi
DOI: https://doi.org/10.1002/macp.200900666
IF: 2.996
2010-01-01
Macromolecular Chemistry and Physics
Abstract:Highly active CaCl 2 ‐modified Zn‐Co(III) DMCs were prepared. XRD results showed that the modified catalyst Ca‐DMC containing 0.14 wt.‐% CaCl 2 was amorphous. A higher polymer yield (>61 kg polymer/g catalyst) and a shorter induction period for ROP of PO were observed for Ca‐DMC than for unmodified DMC catalysts. An initiator had an inhibitory effect on the initiation and polymerization rate of PO ROP. As the molar ratio of the initiator functionality to the catalyst was increased, the reaction rate and polymer yield decreased, whereas the induction period increased. An increase in reaction temperature tended to reduce the polymer yield and broaden the MWD. The 13 C NMR spectrum for an oligomer from a model polymerization without an initiator revealed that the main terminal unit of the polymer was CH 2 CH(CH 3 )OH because H 2 O in the system participated in reaction initiation. Cl − and t ‐BuOH may also initiate the reaction according to the small amounts of terminal CH 2 Cl and OC(CH 3 ) 3 units observed by 13 C NMR spectroscopy. On the basis of common characteristics and some new evidence for DMC catalysis, a mechanism similar to a classical coordination insertion process is proposed. magnified image
What problem does this paper attempt to address?