Bonding Strength and Interface Effects of Different Dentin Bonding Surfaces on Alcohol-water-based Adhesives

Xiaofeng Zhao
2004-01-01
Abstract:Objective To study the microstructure characteristics of alcohol-water-based bonding on dry or wet dentin surface. Methods Two alcohol-water-based wet bonding systems, OptiBond Solo and Single Bond, were used to bond Chrisma B20 resin to dry or moist dentin surface. The bonding interfaces were observed with SEM HITACHI S-2700 scanning electron microscope and microtensile bonding strengths of different groups were measured with Instro 1195. Results Both bonding systems could infiltrate well into dentin bonding interface. Banded collagen and interfibrillar space could be observed at the surface of the acid-conditioned dentin. Hybrid layer formed in demineralized dentin and around the lateral branch of dentinal tubule. No major differences in ultrastructure were observed when the two adhesive systems were bonded to either dry or wet dentin. Microtensile strength had significantly decreased while bonding on dry dentin surface with alcohol-water-based wet bonding systems, with the maximum decrease of 23% in Single Bond. Most of fractures occurred at the bonding interface. Conclusion Alcohol-water-based adhesive can infiltrate well into dentin when bonded to either dry or wet dentin. Water in adhesive can re-expand the air-dried and collapsed collagen network, which can be called self-rewetting effect. Microtensile strength is close to the real dentin bonding strength.
What problem does this paper attempt to address?