Abstract:To achieve high-efficiency operation of the high-gain free-electron laser (FEL), the electron beams and radiated photon beams need to be overlapped precisely and pass through the entire undulator section. Therefore, a high-resolution beam-position monitor (BPM) is required. A cavity BPM (CBPM) with a resonant cavity structure was developed and used in the Shanghai Soft X-ray FEL (SXFEL) test facility and can achieve a position resolution of $$< {1}\upmu \mathrm{m}$$ . The construction and operation of the SXFEL user facility also bring about higher requirements for beam-position measurement. In this case, the factors that affect the performance of the CBPM system were further analyzed. These included the amplitude and phase stability of the local oscillator, stability of the trigger signal, performance of the radio frequency front-end, signal processing electronics, and signal processing algorithms. Based on the upgrade and optimization of the system, a beam test platform was built at the end of the linear acceleration section of the SXFEL, and the experimental results show that the position resolution of the system can reach 177 nm at a bunch charge of 500 pC, and the dynamic range is controlled within $$\pm {300}\upmu \mathrm{m}$$ , and the relative measurement uncertainty of the bunch charge can reach 0.021 $$\%$$ , which are significant improvements compared to the attributes of the previous system.

NEW BEAM DIAGNOSTICS AND RELATED STUDY ON HLS PHOTO- INJECTOR AND HLS II*

New Diagnostic Systems on HL-2A

Optimization of the Cavity Beam-Position Monitor System for the Shanghai Soft X-ray Free-Electron Laser User Facility

In situ beam trajectory tilt measurement based on single cavity beam position monitor

Recent research advances of beam diagnostic system for HLS

Preliminary Design of Bunch-by-bunch Transverse Beam Size System at the HLS-II Storage Ring

HLS Bunch-by-bunch Measurement, Transverse Feedback System and Primary Experiment Results

Beam Instabilities Measurement and Cures at HLS

DESIGN OF CAVITY BEAM QUADRUPOLE MOMENT MONITOR AT HLS

Beam Instrumentation and Diagnostics for HLS

Photon beam position monitor based on position-sensitive detector for HLS

Design of fast beam transverse profile monitor in electron storage ring

Bunch-by-bunch beam current monitor for HLS

Several New Beam Measurement Systems for HLS

Analysis of Some Phenomena in the Commissioning of the Storage Ring in the Phase Ⅱ Project of the HLS

Application and Design of Photon Beam Position Monitor in HLS

Analysis Of Some Phenomena In The Commissioning Of The Storage Ring In The Phase Ii Project Of The Hls

Development Of A Split Photon Beam Position Monitor For Hls

Photon Beam Position Monitor Using Beam Profile System for HLS

Prophase Study of Electron Beam Energy Calibration for HLS

BASELINE DESIGN OF HLS LINAC UPGRADE