Abstract:Double-roller clamping spinning (DRCS) is a new process for forming a thin-walled cylinder with a complex surface flange. The process requires a small spinning force, and can visibly improve forming quality and production efficiency. However, the deformation mechanism of the process has not been completely understood. Therefore, both a finite element numerical simulation and experimental research on the DRCS process are carried out. The results show that both radial force and axial force dominate the forming process of DRCS. The deformation area elongates along the radial direction and bends along the axial direction under the action of the two forces. Both the outer edge and round corner of the flange show the tangential tensile stress and radial compressive stress. The middle region shows tensile tangential stress and radial stress, while the inner edge shows compressive tangential stress and radial stress. Tangential tensile strain causes a wall thickness reduction in the outer edge and middle regions of the flange. The large compressive thickness strain causes material accumulation and thus, an increase in the wall thickness of the round corner. Because of bending deformation, the round corner shows a large radial tensile strain in addition. The inner edge of the flange shows small radial compressive strain and tensile strain in thickness. Thus, the wall thickness on the inner edge of the flange continues to increase, although the increment is small. Furthermore, microstructure analysis and tensile test results show that the flanged thin-walled cylinder formed by DRCS has good mechanical properties. The results provide instructions for the application of the DRCS process.

Finite Element Analysis of Rotating Container in Extrusion Process

Finite Element Analysis and Optimal Researchon Plasticizing Capacity of Screws

Investigation of Metal Extrusion Forming Through Steadily Rotating Container

Simulation Methodology Development for Rotating Blade Containment Analysis

Energy analysis of the extrusion process through a streamlined Gaussian die

SIMULATION OF ALUMINUM FIXTURE PART HOT EXTRUSION PROCESS WITH THE FINITE VOLUME METHOD

FEM simulation and optimization on rotating extrusion of bi-metal rod with constant shear friction

Computer Simulation of Extrusion Process of Intermeshing Co-Rotating Twin Screw Extruders

Numerical Simulation of Influences of Process Parameters on the Spinning Moment and Quality of Double-Roller Clamping Spinning

Numerical Simulation and Process Optimization of Internal Thread Cold Extrusion Process

Numerical Simulation Research on A New Spinning Process: Double-Roller Clamping Spinning Process

Optimization of Extrusion Process Parameters of Incoloy028 Alloy Based on Hot Compression Test and Simulation

Numerical Simulation of Double Rollers Clamping Spinning Process for Flanging

Study on the Influence of the Wheel Angular Velocity on the Continuous Extrusion Forming Process

Analysis on Melting Mechanism in the Cross Section of Co-Rotating Twin Screw Extruder

Numerical Model Simulation of the Double-Roll Rotary Forging of Large Diameter Thin-Walled Disk

Effect of Friction Between Extrusion Container and Billet on Forward Extrusion Forming

Effect of Die Aperture Offset on Flow Behaviour in an Extrusion Process with Aluminium Alloy

Numerical simulation of joint shell extrusion process by using 3-D finite element method

Plastic Deformation Mechanism in Double-Roller Clamping Spinning of Flanged Thin-Walled Cylinder

Effect of Dynamic Center Region on the Flow and Mixing Efficiency in a New Tri-Screw Extruder Using 3D Finite Element Modeling