Abstract:Using cobaloxime boron fluoride (COBF) and AIBN as catalyst and initiator respectively, the catalytic chain transfer bulk polymerization of 2-hydroxyporpyl methacrylate ( HPMA) was carried out at 60 degrees C and the low molecular weight polymer with a terminal double bond was prepared. The evolution of the apparent chain transfer constant (C-S(spp)) of COBF during the polymerization was determined by the Mayo equation and the CLD (chain length distribution) equation respectively. At the beginning of the reaction the chain transfer constant showed values of up to about 2000, but with the increasing of the monomer conversion, the chain transfer constant decreases and keeps at a value of about 600 for sometime and then decreased again. The most likely cause for the catalyst deactivation is the stable cobalt-carbon bond formed at the first period of the reaction and then reached equilibrium point. When the polymerization proceeds up to middle and high conversion, the chain transfer polymerization is further manipulated by diffusions of polymeric propagating chain and catalyst molecules, and the apparent chain transfer constant fell to value of below 300. It has been found also, that the data determined by the CLD equation are usually lower than those by the Mayo equation, especially at high conversion stage. It is because that both original equations are available for the instantaneous produced polymer or the case of very lower conversion stage. However, the GPC measurements give molecular weight distributions of the cumulated products rather than the instantaneous produced polymer. The number-average polymerization degrees for the instantaneous produced polymers were obtained from the GPC data, and used in the Mayo equation method together with the modification of the monomer concentration. It was believed that the apparent chain transfer constants from the modified Mayo equation method are more available for the middle and high conversion cases.

Molar mass determination via linear regression from SEC measurements: The case of polylactide, polycaprolactone and poly(2,2‐dimethylthrimethylene carbonate)

Experimental investigation on the reliability of routine SEC–MALLS for the determination of absolute molecular weights in the oligomeric range

THE EVOLUTION OF THE CHAIN TRANSFER CONSTANT DURING THE CATALYTIC CHAIN TRANSFER POLYMERIZATION OF 2-HYDROXYPROPYL METHACRYLATE

On the Precise Determination of Molar Mass and Dispersity in Controlled Chain-Growth Polymerization: A Distribution Function-Based Strategy

Aqueous Size Exclusion Chromatography applied to polymer analysis: experimental conditions and molecular weight calibration curves

Absolute Quantification for Size Exclusion Chromatography with Differential Refractometry and Light Scattering Dual Detectors

Characterization on the Chain Heterogeneity of L-Lactide and Epsilon-Caprolactone Copolymers

Determination of the Molar Mass of Polyamide Block/Graft Copolymers by Size-Exclusion Chromatography at Room Temperature

A Modified Light-Scattering Method for the Characterization of the Segmented Copolymer Poly(Ethylene Terephthalate-Co-Caprolactone)

High temperature‐size exclusion chromatography with triple detection to assess the molecular architecture of low‐density polyethylene: Insight into branching and processability correlations

Kinetic Parameter Estimation for Linear Low-Density Polyethylene Gas-Phase Process from Molecular Weight Distribution and Short-Chain Branching Distribution Measurements

Low Molar Mass Cyclic Poly(L-lactide)s: Separate Transesterification Reactions of Cycles and Linear Chains in the Solid State

Determination of the Relative Molecular Mass and Composition of Biodegradable Amphiphilic Diblock Copolymer by NMR

[Experimental teaching reform of polymer molar mass determination using gel permeation chromatography coupled with light scattering]

Raman evaluation of the crystallinity degree and composition of poly(L-lactide-co-ε-caprolactone)

Characterizing Styrene Monomer and Oligomers by SEC/MALS/VISC/DRI

Size-exclusion chromatography–electrospray-ionization mass spectrometry to characterize end group and chemical distribution of poly(lactide-co-glycolide) co-polymers

Determination of the macromolecular dimensions of hydrophobically modified polymers by micellar size exclusion chromatography coupled with multiangle light scattering

QUANTITATIVE CHARACTERIZATION OF COMPLEX FORMATION OF A PMMA/PEG SOLUTION BY SEC-LS

Characterization of mesogen-jacketed liquid crystalline polymers by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry

Relation between molecular weight and intrinsic viscosity for polymethyl methacrylate