Abstract:The phase structures and transition behaviors of a series of mesogen-jacketed liquid crystalline (LC) polymers, poly{2,5-bis[(4-methoxyphenyl)oxycarbonyl]styrenes} (PMPCS), with different molecular weights (MW) and narrow MW distributions were studied using differential scanning calorimetry, polarized light microscopy, Fourier transform infrared spectroscopy, and one- and two-dimensional wide-angle X-ray diffraction experiments. The LC phase structures of this series of PMPCS samples were found to be strongly MW dependent. The PMPCS samples were amorphous when the MW is lower than a critical MW of approximately 1.0 x 10(4) g/mol (an apparent MW, M-n(a), measured by gel permeation chromatography calibrated with the polystyrene standards). For the PMPCS samples with MWs higher than this critical value, the amorphous samples cast from solution developed into a LC phase above the glass transition temperature upon the first heating. In between 1.0 x 10(4) g/mol < Ma < 1.6 x 10(4) g/mol, a columnar nematic (Phi(N)) phase was stabilized. Above the M-n(a) = 1.6 x 10(4) g/mol, a hexatic columnar nematic (Phi(HN)) phase was observed. Within these two LC phases, the building blocks were cylindrical shaped, which was attributed to a cooperative assembly of the PMPCS backbone and its laterally attached mesogenic groups. The diameter of this cylindrical building block was in the vicinity of 1.6 nm as determined by WAXD experiments. All the LC phases were found to be stable up to the decomposition temperature of the PMPCS samples. The MW dependence of the LC phase diagram indicated that a critical aspect ratio (the ratio between the length and diameter of the cylinders) of the cylindrical building blocks must be required to stabilize these LC phases. On the basis of Flory's calculation, the critical aspect ratio should be 5.44, and this value corresponded to critical cylinder lengths of around 8-9 nm. Therefore, the lowest degree of polymerization which would stabilize the LC phases is similar to39-42 for this series of PMPCS samples.

Characterization of mesogen-jacketed liquid crystalline polymers by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry

Quantitative Analysis of Synthetic Polymers Using Matrix-Assisted Laser Desorption/ionization Time-of-flight Mass Spectrometry.

Influence of Molecular Weight on Liquid Crystalline Behavior of Linear and Star Mesogen‐jacketed Liquid Crystal Polymers

Synthesis and Properties of New Mesogen-Jacketed Liquid Crystalline Polymers

Optimized MALDI-TOF MS Strategy for Characterizing Polymers

Star mesogen-jacketed liquid crystalline polymers with silsesquioxane core: Synthesis and characterization

Design, synthesis, and characterization of a combined main‐chain/side‐chain liquid crystalline polymer based on mesogen‐jacketed liquid crystal polymer via atom transfer radical polymerization

Molecular Weight Dependence of Phase Structures and Transitions of Mesogen-Jacketed Liquid Crystalline Polymers Based on 2-Vinylterephthalic Acids

Amorphous poly-N-vinylcarbazole polymer as a novel matrix for the determination of low molecular weight compounds by MALDI-TOF MS

Applications of Matrix-Assisted Laser Desorption/Ionization Time-Of-Flight in Polymer Studies

Synthesis and Characerization of A Series of Mesogen-Jacketed Liquid Cryatalline Polymers with Long Mesogenic Side Chains

Synthesis and Characterization of Mesogen-Jacketed Liquid Crystalline Polymers Through Hydrogen-Bonding

Synthesis and Properties of a Series of Mesogen-Jacketed Liquid Crystalline Polymers with Polysiloxane Backbones

Design and Synthesis of a Series of Novel Mesogen-Jacketed Liquid Crystal Polymers

Direct Laser Desorption/ionization Time-of-flight Mass Spectrometry of Conjugated Polymers.

Effects of Molecular Weight on Liquid-Crystalline Behavior of a Mesogen-Jacketed Liquid Crystal Polymer Synthesized by Atom Transfer Radical Polymerization

Synthesis and Characterization of Novel Mesogen‐Jacketed Liquid Crystalline Miktoarm Star Rod‐Coil Block Copolymer

Synthesis and properties of mesogen-jacketed liquid crystalline polymers containing biphenyl mesogen with asymmetric substitutions

Synthesis and Properties of Mesogen‐jacketed Liquid Crystalline Polymers Containing Bistolane Mesogen

Characterization of Insoluble Polyamide-6,T by Maldi-Tof Ms

Unusual Phase Behavior of a Mesogen-Jacketed Liquid Crystalline Polymer Synthesized by Atom Transfer Radical Polymerization