Abstract:Isolated DC-DC converters are considered the building blocks of modern aircraft electrical power networks. The high-frequency transformer utilized in such converters is the major contributor to the size and weight besides the thermal management system. In this paper, an optimization design methodology aims to minimize the transformer core size and improve the converter performance through optimized winding configurations. The transformer core selection is based on optimizing the maximum flux density while considering different magnetic materials and number of cores in parallel. The transformer core is selected for an interleaved winding configuration and to keep the windings current density below a certain limit. The trade-offs between the converter efficiency and core weight in selecting an optimum switching frequency are presented. Multi-layer minimum gradient (MLMG) winding configurations are proposed to eliminate the high-frequency oscillations (HFO) caused by the transformer parasitics. The proposed configurations resulted in a reduction of the intra-winding capacitance by 15 times with 20$\%$ improvement in the transformer volume as compared to a similar conventional double-layers spiral configurations. Numerical simulations are performed in ANSYS Maxwell to validate the proposed design and the developed analytical models. The effect of the different configurations on the converter performance is verified in the PLECS simulation environment. PLECS simulation results are validated experimentally for the conventional and proposed configurations highlighting the improvements on the performance of the converter.

Reduction of Copper Loss of Planar Transformers Based on Optimized Width Winding

An Optimization Method for Planar Transformer Winding Losses in GaN Based Multi-output Flyback Converter

Simplified Analytical Model and Investigation of Open-Circuit AC Winding Loss of Permanent-Magnet Machines.

A novel PCB winding transformer with controllable leakage integration for a 6.6kW 500kHz high efficiency high density bi-directional on-board charger

Inhomogeneous Winding for Loosely Coupled Transformers to Reduce Magnetic Loss

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

A High Power Density 48V-12V DCX with 3-D PCB Winding Transformer

A WBG based three phase 12.5 kW 500 kHz CLLC resonant converter with integrated PCB winding transformer

Modelling and Optimisation of Planar Matrix Transformer for High Frequency Regulated LLC Converter

Winding Loss Reduction Based on the Even Magnetomotive Force in the Wide-Range RDCX Converter for OBC

High Power Density 48–12 V DCX with 3-D PCB Winding Transformer

Design of the Number of Transformer Shielding Winding Turns for Minimizing Low-Frequency Common-Mode Noise in Flyback Converters

Optimized Design of Full‐Bridge LLC Planar Transformer Based on Variable‐Width Windings

Winding loss optimization for planar transformer in LLC resonant converter

2-D Analytical Copper Loss Model for PCB and Copper Foil Magnetics with Arbitrary Air Gaps

Modeling and Evaluation of Winding Losses in High Voltage Planar Transformers

A Novel Pyramid Winding for PCB Planar Inductors with Fewer Copper Layers and Lower AC Copper Loss

Optimized Design of Integrated Planar Matrix Transformer for LLC Converter in Consumer Electronics

Loss-Optimized Design of Magnetic Devices

Design Optimization Methodology for Planar Transformers for More Electric Aircraft

Litz-Wire Winding Loss Calculation Method for Optimal Design of High-Frequency Transformers