Abstract:Abstract Using steam as a heat carrier and working media has merits to increase electric efficiency up to 60% and decrease NOx emission to single-digit compared to dry gas turbine cycles. These attribute primarily to the physical properties of steam as having high heat capacity to reduce local flame temperature, and hence reduce emissions by inhibiting the thermal NOx forward reaction rate. In this work, ultrahigh steam content with a steam-to-air mass ratio of up to 40% is premixed with methane–air mixture before entering into a swirl-stabilized high pressure (HP)-burner for combustion. A significant change of flame from V-shape (attached) to M shape (detached) is observed through a transparent combustion chamber whilst changing steam content. The measurement of chemiluminescence OH* is conducted with an intensified CCD-camera bandpass filtered at 320 nm. Following these measurements, large eddy simulation (LES) is used to capture reacting flow features. Reasonably well agreements between experimental data and numerical results are obtained for both attached and detached flames in terms of the OH* distribution. Slight inconsistency of OH* intensity is mainly due to uncollected wall temperature, which leads to either over- or underprediction of chemical reaction rate depending on the experimental flame positions. Distributed flame front is clearly identified with LES for wet methane combustion associated with 35% steam-to-air ratio corresponding to a high Karlovitz number flame. Slightly unstable combustion is observed when the steam-to-air ratio exceeds 40% featuring an onset of flame blow-off. In addition, interaction between precessing vortex core (PVC) and the flame is presented for different level of steam dilution, and conclusions are drawn regarding the flame stabilization. The in-depth understanding of the ultrawet combustion is an important step toward the use of sustainable, steam-diluted biosyngas for electricity production.

Numerical Simulation Study on Plasma Rapid Heater of Methane

Kinetic Modeling and Experimental Validation of the Pyrolysis of Propane in Hydrogen Plasma

Numerical Simulation of the Entrained Flow Hydropyrolysis of Coal in Magnetically Rotating Plasma Reactor

Numerical Study of Methane to Acetylene Process in Novel Thermal Plasma Array Reactor

Numerical simulation of heating process of supercritical methane in Printed Circuit Heat Exchanger

Experimental Comparison of Methane Pyrolysis in Thermal Plasma

Improvement of Plasma Reactor Design for Methane Pyrolysis by Simulation

Three-dimensional Simulation of a Novel Microwave-Assisted Heating Device for Methyl Ricinoleate Pyrolysis

Numerical Studies of Supercritical Turbulent Convective Heat Transfer of Cryogenic-Propellant Methane

Numerical Study on the Characteristics of Methane Hedging Combustion in a Heat Cycle Porous Media Burner

Numerical Simulation on Heat Transfer and Flow of Supercritical Methane in Printed Circuit Heat Exchangers

Multiscale Modeling of Plasma-Assisted Non-Premixed Microcombustion

Numerical Simulation Analysis of Heating Effect of Downhole Methane Catalytic Combustion Heater under High Pressure

Experimental and Numerical Investigation of Ultra-Wet Methane Combustion Technique for Power Generation

Numerical Simulation of Hydrogen Production from Rich Combustion of Methane in Built-in Porous Media Swiss-roll Reactor

On design of plasma jet reactor for non-oxidative methane conversion

A computational study of a laminar methane-air flame assisted by nanosecond repetitively pulsed discharges

Dynamics Simulations of a Novel Heat-Exchange Methane Reformer Using an Eelectrically Heated Alumite Catalyst

Numerical study on methane heterogeneous reaction characteristics in micro catalytic combustors with orthogonal thermal anisotropic walls

Plasma-Assisted Ignition and Combustion of Methane-Air Mixtures Using Dielectric Barrier Discharge

Numerical Simulation of Transient Multiphase Field During Hybrid Plasma-Laser Deposition Manufacturing