Abstract:A micromixer is one of the most significant components in a microfluidic system. A three-dimensional micromixer was developed with advantages of high efficiency, simple fabrication, easy integration, and ease of mass production. The designed principle is based on the concepts of splitting–recombination and chaotic advection. A numerical model of this micromixer was established to characterize the mixing performance for different parameters. A critical Reynolds number (Re) was obtained from the simulation results. When the Re number is smaller than the critical value, the fluid mixing is mainly dependent on the mechanism of splitting–recombination, therefore, the length of the channel capable of complete mixing (complete mixing length) increases as the Re number increases. When the Re number is larger than the critical value, the fluid mixing is dominated by chaotic advection, and the complete mixing length decreases as the Re number increases. For normal fluids, a complete mixing length of 500 µm can be achieved at a very small Re number of 0.007 and increases to 2400 µm as the Re number increases to the critical value of 4.7. As the Re number keep increasing and passes the critical Re number, the complete mixing length continues to descend to 650 µm at the Re number of 66.7. For hard-to-mix fluids (generally referring to fluids with high viscosity and low diffusion coefficient, which are difficult to mix), even though no evidence of strong chaotic advection is presented in the simulation, the micromixer can still achieve a complete mixing length of 2550 µm. The mixing performance of the micromixer was also verified by experiments. The experimental results showed a consistent trend with the numerical simulation results, which both climb upward when the Re number is around 0.007 (flow rate of 0.03 μm/min) to around 10 (flow rate of 50 μm/min), then descend when the Re number is around 13.3 (flow rate of 60 µm/min).

Mixing in a co-flow-focusing structured droplet-based micromixer

An efficient micromixer combining oscillatory flow and divergent circular chambers

Experimental and Numerical Study of Mixing Behavior Inside Droplets in Microchannels

An Enhanced Electroosmotic Micromixer with an Efficient Asymmetric Lateral Structure.

Fluid Mixing in Droplet‐based Microfluidics with T Junction and Convergent–divergent Sinusoidal Microchannels

Synthesis of scalable microdroplets with fluid instability of shearing flow in microfluidics

Fluid flow and mixing characteristics in micromixer with vortex-generated structures

An Investigation of Flow Patterns and Mixing Characteristics in a Cross-Shaped Micromixer within the Laminar Regime

Numerical Simulation and Structural Recombination of Microchannel Micromixer for Excellent Mixing Performance

Numerical Investigation of Multiscale Lateral Microstructures Enhancing Passive Micromixing Efficiency Via Secondary Vortex Flow

Enhanced Mixing of Binary Droplets Induced by Capillary Pressure

Mass Transfer and Mixing Performance in Jet-to-counterflow Micromixer

Numerical study of a novel electroosmotic active micromixer with twin diamond-shaped chambers and sawteeth

A Novel Micromixer That Exploits Electrokinetic Vortices Generated on a Janus Droplet Surface.

Optimization of G1 Micromixer Structure in Two-Fluid Mixing Based on CFD and Response Surface Methodology

Investigation of Efficient Mixing Enhancement in Planar Micromixers with Short Mixing Length

Numerical Investigation of Mixing Efficiency in Janus Micro-Mixer Using Lattice Boltzmann Method

Design and Evaluation of an Easily Fabricated Micromixer with Three-Dimensional Periodic Perturbation

Influence of coaxiality on internal mixing of coflow generated droplets

Highly Efficient and Controllable Micromixer Through Interactions of Photothermal Multi-Vortices

A Three-Dimensional Micromixer Using Oblique Embedded Ridges