Abstract:In the midst of the COVID-19 pandemic, new requirements for clean air supply are introduced for heating, ventilation, and air conditioning (HVAC) systems. One way for HVAC systems to efficiently remove airborne viruses is by filtering them. Unlike disposable filters that require repeated purchases of consumables, the electrostatic precipitator (ESP) is an alternative option without the drawback of reduced dust collection efficiency in high-efficiency particulate air (HEPA) filters due to dust buildup. The majority of viruses have a diameter ranging from 0.1 μm to 5 μm. This study proposed a two-stage ESP, which charged airborne viruses and particles via positive electrode ionization wire and collected them on a collecting plate with high voltage. Numerical simulations were conducted and revealed a continuous decrease in collection efficiencies between 0.1 μm and 0.5 μm, followed by a consistent increase from 0.5 μm to 1 μm. For particles larger than 1 μm, collection efficiencies exceeding 90% were easily achieved with the equipment used in this study. Previous studies have demonstrated that the collection efficiency of suspended particles is influenced by both the ESP voltage and turbulent flow at this stage. To improve the collection efficiency of aerosols ranging from 0.1 μm to 1 μm, this study used a multi-objective genetic algorithm (MOGA) in combination with numerical simulations to obtain the optimal parameter combination of ionization voltage and flow speed. The particle collection performance of the ESP was examined under the Japan Electrical Manufacturers’ Association (JEMA) standards and showed consistent collection performance throughout the experiment. Moreover, after its design was optimized, the precipitator collected aerosols ranging from 0.1 μm to 3 μm, demonstrating an efficiency of over 95%. With such high collection efficiency, the proposed ESP can effectively filter airborne particles as efficiently as an N95 respirator, eliminating the need to wear a mask in a building and preventing the spread of droplet infectious diseases such as COVID-19 (0.08 μm–0.16 μm).

Numerical Evaluation of Respiratory Droplet Removal by an Ionic Wind-Driven Electrostatic Device in an Indoor Environment

Introduction and Simulation of a Small Electro Cyclone for Collecting Indoor Pollen Particles

Characterization of Electrohydrodynamic Flow in a Plate-Plate Electrostatic Precipitator with a Wire-Cylinder Pre-Charger by Data-Driven Vortex and Residence Time Analysis

Electric charge effect of micro-droplets generated by electrospray atomization on removal of indoor fine particulate matter

Fog Droplet Collection by Corona Discharge in a Needle-Cylinder Electrostatic Precipitator with a Water Cooling System

Numerical Comparison of the Efficiency of Mixing Ventilation and Impinging Jet Ventilation for Exhaled Particle Removal in a Model Intensive Care Unit

Experimental Investigation of Electrostatic Reduction in a Gas–Solid Fluidized Bed by an in Situ Corona Charge Eliminator

A Numerical Model for Predicting Particle Collection Efficiency of Electrostatic Precipitators

Numerical analysis of turbulence field and particle trajectory inside wet Electrostatic Precipitator

Development and Experimental Investigation of the Narrow-Gap Coated Electrostatic Precipitator with a Shield Pre-Charger for Indoor Air Cleaning

Extremely Inexpensive and Simple Method To Remove Indoor Respiratory Aerosols

Indoor airborne disinfection with electrostatic disinfector (ESD): Numerical simulations of ESD performance and reduction of computing time

Optimizing indoor air quality: CFD simulation and novel air cleaning methods for effective aerosol particle inhibition in public spaces

A New Approach Based on the Augmented Particle Sink Effect to Remove Indoor Airborne Particulate Matter: Experimental Study

Electrostatic Precipitator Design Optimization for the Removal of Aerosol and Airborne Viruses

Numerical Simulation of Corona Discharge and Particle Transport Behavior with the Particle Space Charge Effect

Numerical study on the effect of staggered wire electrodes in an electrostatic precipitator

Simultaneous effects of electrostatic field and thermophoresis on inhalable particulate matter removal

The effectiveness of an air cleaner in controlling droplet/aerosol particle dispersion emitted from a patient's mouth in the indoor environment of dental clinics.

Performance and techno-economic evaluation of a high-efficiency electrospray cyclone

Enhancing the capturing characteristics of charged droplets on submicron particles: An experimental and numerical investigation