Abstract:Radioactive iodine isotopes especially 131 I are used for diagnosis and treatment of different types of cancer diseases. Due to the leak of radioactive iodine into the patient's urine in turn, the wastewater would be contaminated, so it is worth preparing a novel adsorption green material to remove the radioactive iodine from wastewater efficiently. The removal of 127 I and 131 I contaminants from aqueous solution is a problem of interest. Therefore, this work presents a new study for removing the stable iodine 127 I − and radioactive iodine 131 I from aqueous solutions by using the novel nano adsorbent (Nano ZnO/MWCNTs) which is synthesized by the arc discharge method. It is an economic method for treating contaminated water from undesired dissolved iodine isotopes. The optimal conditions for maximum removal are (5 mg/100 ml) as optimum dose with shacking (200 rpm) for contact time of (60 min), at (25 °C) in an acidic medium of (pH = 5). After the adsorption process, the solution is filtrated and the residual iodide ( 127 I − ) is measured at a maximum UV wavelength absorbance of 225 nm. The maximum adsorption capacity is (15.25 mg/g); therefore the prepared nano adsorbent (Nano ZnO/MWCNTs) is suitable for treating polluted water from low iodide concentrations. The adsorption mechanism of 127 I − on to the surface of (Nano ZnO/MWCNTs) is multilayer physical adsorption according to Freundlich isotherm model and obeys the Pseudo-first order kinetic model. According to Temkin isotherm model the adsorption is exothermic. The removal efficiency of Nano ZnO/MWCNTs for stable iodine ( 127 I − ) from aqueous solutions has reached 97.23%, 89.75%, and 64.78% in case of initial concentrations; 0.1843 ppm, 0.5014 ppm and 1.0331 ppm, respectively. For the prepared radio iodine ( 131 I − ) solution of radioactivity (20 μCi), the dose of nano adsorbent was (10 mg/100 ml) and the contact time was (60 min) at (pH = 5) with shacking (200 rpm) at (25 °C). The filtration process was done by using a syringe filter of a pore size (450 nm) after 2 days to equilibrate. The removal efficiency reached (34.16%) after the first cycle of treatment and the percentage of residual radio iodine was (65.86%). The removal efficiency reached (94.76%) after five cycles of treatment and the percentage of residual radio iodine was (5.24%). This last percentage was less than (42.15%) which produces due to the natural decay during 10 days.

Highly Efficient Iodide Adsorption from Medical Radioactive Wastewater by Strong Alkaline Anion Exchange Fiber

Safe disposal of radioactive iodide ions from solutions by Ag2O grafted sodium niobate nanofibers

Synthesis of Amyloid Fibrils-Pei Hybrid Membrane for Efficient Removal of 99mtc from Medical Wastewater

Alkaline Ion Exchange Fibers Constructed by UV-induced Radical Polymerization for Efficient Uranium Recovery from Wastewater and Seawater

Ultralight crystalline hybrid composite material for highly efficient sequestration of radioiodine

Efficient removal of radioactive iodide from contaminated seawater by radiation-resistant Ag+-doping polypropylene nonwoven adsorbents

Treatment of iodide from simulated radioactive wastewater using novel countercurrent two-stage adsorption process

The Rapid Removal of Iodide from Aqueous Solutions Using a Silica-Based Ion-Exchange Resin

Enhanced removal of radioactive iodine anions from wastewater using modified bentonite: Experimental and theoretical study

Rapid and selective removal of radioactive iodide ions from wastewater via bismuth-based metal-organic frameworks

Efficient Removal of Radioactive Iodine Anions Using Δ-Bi2o3/Mof-808 Through Photo-Oxidation and Adsorption: Performance Evaluation and Investigation of Synergistic Mechanisms

Enhanced Removal of Iodide Ions by Nano Cu2O/Cu Modified Activated Carbon from Simulated Wastewater with Improved Countercurrent Two-Stage Adsorption

Lignin-based Electrospinning Nanofibers for Reversible Iodine Capture and Potential Applications.

Cross-linked Chitosan Microspheres: an Efficient and Eco-Friendly Adsorbent for Iodide Removal from Waste Water.

Removal of Radioactive Iodine Using Silver/Iron Oxide Composite Nanoadsorbents

Impact of (nano ZnO/multi-wall CNTs) prepared by arc discharge method on the removal efficiency of stable iodine 127I and radioactive iodine 131I from water

Bimetal ZIFs-derived Cu0 embedded in nitrogen-doped carbon framework activation of molecular oxygen for efficient iodide elimination

A chitosan film implanted with g-C3N4@Ag nanosheets and in-suit formed AgCl nanoparticles for efficient iodide removal

Highly Selective Adsorption of 99TcO4−/ReO4− by a Novel Polyamide-Functionalized Polyacrylamide Polymer Material

Adsorption-induced Chemical Reaction for in Situ Immobilization of Radioactive Anions on Pristine Β-Bi2o3 Microflowers

Iodide ion-imprinted chitosan beads for highly selective adsorption for nuclear wastewater treatment applications