Abstract:In a high-current interruption, the contact surface in a vacuum interrupter might be severely damaged by constricted vacuum arcs causing a molten area on it. As a result, a protrusion will be initiated by a transient recovery voltage after current zero, enhancing the local electric field and making breakdowns occur easier. The objective of this paper is to simulate the deformation process on the molten area under a high electric field by adopting the finite element method. A time-dependent Electrohydrodynamic model was established, and the liquid-gas interface was tracked by the level-set method. From the results, the liquid metal can be deformed to a Taylor cone if the applied electric field is above a critical value. This value is correlated to the initial geometry of the liquid metal, which increases as the size of the liquid metal decreases. Moreover, the buildup time of a Taylor cone obeys the power law t = k × E−3, where E is the initial electric field and k is a coefficient related to the material property, indicating a temporal self-similar characteristic. In addition, the influence of temperature has little impact on the deformation but has great impact on electron emission. Finally, the possible reason to initiate a delayed breakdown is associated with the deformation. The breakdown does not occur immediately when the voltage is just applied upon the gap but is postponed to several milliseconds later when the tip is formed on the liquid metal.

Establishment and Application of Rebound Dynamics Model for High-Voltage DC Contactor

Research on Voltage Stability of HVDC Receiving-end System Based on Power Limit Trajectory

Simulation Study On The Control Valve In Hydraulic Operating Mechanism Of The High Voltage Circuit Breaker

A Novel Method for Calculating Residual Magnetic Flux of DC Contactors

Research on the Influence of Current Limiter Based on Highly Coupled Split Reactor on Main Circuit Breaker Overvoltage

Cushion Process of the Hydraulic Cylinder of Hydraulic Operating Mechanism for High Voltage Circuit Breaker

Comprehensive Modeling, Optimization and Experiment of 10 kV/15 kA Forced Resonant DC Circuit Breaker

Research on Electrical Contact Characteristics of Brush-Rail Device With Transient Large Current

Contact Parameter Computation and Analysis of Air Circuit Breaker with Permanent Magnet Actuator

Study of the Electromagnetic-Dynamics Interaction of the Breaking Process of Low-Voltage Molded Case Circuit Breaker

Investigation on the Controlling Techniques of Moving Contact Behaviors for Vacuum Circuit Breaker with Permanent Magnetic Actuator

A Direct Electromagnetic Force Closed-loop Control Strategy for a Contactor

Deformation of contact surfaces in a vacuum interrupter after high-current interruptions

Dynamic fault analysis model development for vacuum circuit breaker action

Integrated Low Voltage Apparatus

Multifunction integrated low voltage apparatus

Research on an intelligent operating mechanism of high voltage circuit breaker

Research on Contact Structure in Vacuum Interrupter for DC Breaking Capability

DC Contactor Energy Conversion Research

Research on 10kv Quick Vacuum Circuit Breaker with Double Opening and Closing Coils

Research on the Characteristic of the Electrical Contact Resistance of Strap Contacts Used in High Voltage Bushings