Abstract:In traditional wastewater treatment methods, the removal of emerging contaminants including perfluorooctanoic acid (PFOA) can be challenging. To address this, biochar is commonly utilized as an activator for peroxymonosulphate (PMS) to effectively eliminate organic pollutants. Sewage sludge has shown potential as a biochar precursor, but its complex composition and variable iron content, as well as the low specific surface area of the product limit the practical use of iron-dominated sludge-derived catalysts. To overcome this limitation, N-doped citrate-sludge-derived carbon (NCSC) was synthesized, possessing a low iron content (0.29 at%) and a large specific surface area (315.31 m2 g-1). As a comparison, Fe-/N-doped citrate-sludge-derived carbon (Fe-NCSC) was prepared by introducing exogenous iron, resulting in a higher iron content (2.12 at%) but a significantly reduced specific surface area (73.87 m2 g-1). In performance evaluation, the NCSC/PMS system achieved impressive removal efficiency, effectively eliminating 99.8% of PFOA (at an initial concentration of 2 mg L-1) within 60 min, while Fe-NCSC/PMS only achieved 84.6%. The slightly lower reaction rate per specific surface area of NCSC/PMS proved that large specific surface area was NCSC's key advantage. The lower sensitivity of NCSC to pH and water substrates than FeNCSC suggested different activation mechanisms. Further analysis of reactive sites and species showed that the main oxidation mechanism of NCSC/PMS was forming the surface-bound PMS-NCSC complexes at the N sites, followed by PFOA donating electrons to the complexes to be oxidized, which was different from the Fe/N-dominated singlet oxygen mechanism of Fe-NSC/PMS. Furthermore, the reusability of the NCSC was demonstrated, with the removal rate decreasing to only 90.1% after four cycles and recovering to 94.8% after heated regeneration. In conclusion, this study provides a viable method for the elimination of emerging contaminants such as PFOA in water remediation.

In-Situ Photothermal Regeneration of Fulvic Acid-Saturated Co@NC Magnetic Nanoparticles Via Persulfate Oxidation

Self-immobilization of a Magnetic Biosorbent and Magnetic Induction Heated Dye Adsorption Processes

On-site regeneration by ultrasound activated persulfate of iron-rich Antipyrine-loaded biochar

Magnetic Carbon Nanotubes Synthesis by Fenton'S Reagent Method and Their Potential Application for Removal of Azo Dye from Aqueous Solution

Selective removal of organic contaminants and ascorbic acid enhancement effect based on the magnetic Fe0/FeS2-doped carbon nanolayer

In Situ Regeneration of Phenol-Saturated Activated Carbon Fiber by an Electro-peroxymonosulfate Process.

N-doped citrate-sludge-derived carbon (NCSC) effectively promotes peroxymonosulfate activation for perfluorooctanoic acid (PFOA) removal with surface-mediated electron transfer mechanism

Reutilization of waste self-heating pad by loading cobalt: A magnetic and green peroxymonosulfate activator for naphthalene degradation

Polydopamine-coated Carbonized Cotton Fabrics with Β-Feooh Nanorods Composites for Highly Efficient Photo-Fenton Degradation of Organic Pollutants

Surface Oxidized Nano-Cobalt Wrapped By Nitrogen-Doped Carbon Nanotubes For Efficient Purification Of Organic Wastewater

Integrating Adsorption and In-Situ Catalytic Regeneration on N Doped Carbon Aerogel for Sustainable Continuous-Flow Water Treatment

Strongly Coupled Fe/N Co-Doped Graphitic Carbon Nanosheets/carbon Nanotubes for Rapid Degradation of Organic Pollutants Via Peroxymonosulfate Activation: Performance, Mechanism and Degradation Pathways

Nanosized Co-Fe spinel quantum dots anchored on activated carbon for enhanced VOCs mineralization via PMS-based AOPs coupled with wet scrubber

Core-shelled Mesoporous CoFe2O4–SiO2 Material with Good Adsorption and High-Temperature Magnetic Recycling Capabilities

Preparation of Sludge Derived Magnetic Porous Carbon and Their Application in Fenton-like Degradation of 1-Diazo-2-naphthol-4-sulfonic Acid.

MOF Derived Co−Fe nitrogen doped graphite carbon@crosslinked magnetic chitosan Micro−nanoreactor for environmental applications: Synergy enhancement effect of adsorption−PMS activation

Efficient Degradation of Organic Pollutants Using Peroxydisulfate Activated by Magnetic Carbon Nanotube

One-Step Carbothermal Synthesis of Super Nanoadsorbents for Rapid and Recyclable Wastewater Treatment

A Magnetic CoFe2O4-CNS Nanocomposite As an Efficient, Recyclable Catalyst for Peroxymonosulfate Activation and Pollutant Degradation

Self-cycled Photocatalytic Fenton System and Rapid Degradation of Organic Pollutants over Magnetic 3D MnS Nanosheet/iron-Nickel Foam

Looped Carbon Capturing and Environmental Remediation: Case Study of Magnetic Polypropylene Nanocomposites