Abstract:A high-temperature and high-pressure gas field in an oil field requires the use of super 13 chromium material due to corrosive environments. In the recent production process, there have been four consecutive cases of corrosion, fracture, and perforation of tubing nipples, which have brought enormous economic losses to the oilfield. This article analyzes the failure causes of these four tubing nipples and proposes preventive measures. In this paper, the macroscopic morphology, chemical composition, mechanical properties, metallography, and microscopic morphology of four failed tubing nipples have been analyzed. Combined with the field service conditions and string structure of the tubing nipples, it is believed that the failure of the tubing nipples is mainly due to the connection of carbon steel and stainless steel materials, forming a typical galvanic corrosion galvanic cell. The geometric and environmental factors of the materials exacerbate this corrosion. Eventually, severe galvanic corrosion occurred on the inner surface of the tubing nipple, resulting in severe wall thinning or partial perforation, and four tubing nipples failed. The failed tubing nipples in Wells A, B, and C have erosion marks, which are caused by the action of high pressure and high flow rate fluids in the well; The inner surface of the tubing nipple in Well D is rusty yellow, mainly due to the corrosion of its inner wall caused by the acid fracturing fluid injected earlier. At the same time, the string structure of four wells shows that the tubing nipple is located at the variable diameter node of the string. When the fluid in the well flows from the large hole into the smaller hole, the fluid in the well will change there, and its flow rate and pressure will also increase, further exacerbating the erosion in this area. With the development of deep wells containing carbon dioxide in oil fields and the application of carbon dioxide injection secondary oil recovery technology, the use of 13Cr martensitic stainless steel is also increasing. In order to avoid the occurrence of similar accidents that will bring huge economic losses to the oil field, it is recommended that the material of the pipe string (including accessories) of such wells be confirmed using a portable direct reading spectrometer before entering the well.

Stress Analysis of Special Thread Tightness of Injection Production String in Salt Cavern Gas Storage

Study on the Effect of the Water Injection Rate on the Cavern Leaching Strings of Salt Cavern Gas Storages

An Assessment of Seal Ability of Tubing Threaded Connections: A Hybrid Empirical-Numerical Method

Safety analysis of pipe string strength during transient process of ultrahigh temperature and high pressure well fracturing

Experimental and Numerical Simulation on the Generation and Development of Cumulative Plastic Strain of Cement Sheath in Salt Cavern Gas Storage Well

A novel thread connection structure of slimehole drilling tool in ultra-deep natural gas well

Modeling Surface Roughness and Flow of Gases in Threaded Connections to Analyze Sealing Performance

Study on Sealing Failure of Wellbore in Bedded Salt Cavern Gas Storage

Tightness and stability evaluation of salt cavern underground storage with a new fluid–solid coupling seepage model

A special thread design for failure prevention of expandable casing

Investigation of the influence of the location of the main plane of the thread on the stress-strain state of the locking threaded connection of the elements of the drill string

Experimental study on flow-induced vibration response characteristics of leaching tubing in salt cavern gas storage

Investigation of the tensile strain response of the girth weld of high-strength steel pipeline

Experimental study on vibration characteristics of salt cavern leaching tubing for underground natural gas storage

Safety evaluation method of tubing strings in high-pressure, high-temperature and high-yield gas wells based on FIV analysis

Experimental investigation of dynamic characteristics of leaching tubing for solution mining of salt cavern carbon and energy storage

Finite Element Simulations of Working Characteristics of Solid Expandable Tubular Threaded Joint

Nonlinear Analysis of the Threaded Connection with Three-Dimensional Finite Element Model

Corrosion Analysis and Prevention of Tubing Nipples in Four Wells

Fracture analysis of X80 welded joints with variable wall thickness and misalignment

Multistring analysis of wellhead movement and uncemented casing strength in offshore oil and gas wells