Abstract:Abstract Recent years have witnessed that the prefabricated concrete structure is in the widespread use of building structures. This structure, however, still has some weaknesses, such as excessive weight of components, high requirements for construction equipment, difficult alignment of nodes, and poor installation accuracy. In order to handle the problems mentioned above, the prefabricated component made of lightweight concrete is adopted. At the same time, this prefabricated component is beneficial to reducing the load of the building structure itself and improving the safety and economy of the building structure. Nevertheless, it is rarely found that the researches and applications of lightweight concrete for stressed members are conducted. In this context, this paper replaces ordinary coarse aggregate with lightweight ceramsite or foam based on the C60 concrete mix ratio so as to obtain a mix ratio of C40 lightweight concrete that meets the engineering standards. Besides, ceramsite concrete beams and foamed concrete beams are fabricated. Moreover, through three-point bending tests, this paper further explores the mechanical properties of lightweight concrete beams and plain concrete beams during normal use conditions. As demonstrated in the results, the mechanical properties of the foamed concrete beam are similar to those of the plain concrete beam. Compared to plain concrete beams, the density of foamed concrete beams was lower by 23.4%; moreover, the ductility and toughness of foamed concrete were higher by 13% and 3%, respectively. However, in comparison with the plain concrete beam, the mechanical properties of the ceramsite concrete beam have some differences, with relatively large dispersion and obvious brittle failure characteristics. Moreover, in consideration of the nonlinear deformation characteristics of reinforced concrete beams, the theoretical calculation value of beam deflection was given in this paper based on the assumption of flat section and the principle of virtual work. The theoretically calculated deflection values of ordinary concrete beams and foamed concrete beams are in good agreement with the experimental values under normal use conditions, verifying the rationality and effectiveness of the calculation method. The research results of this paper can be taken as a reference for similar engineering designs.

Comparison of the Beam Mechanical Properties Between the CDG Based Geopolymer Concrete and OPC Concrete

Compressive Strength and Chloride Resistance of Slag/Metakaolin-Based Ultra-High-Performance Geopolymer Concrete.

Experimental Study on the Effects of Calcium-rich Materials on the Early Compressive Strength of Completely Decomposed Granite (CDG) Base-geopolymer

Study on Factors Affecting the Mechanical Properties of Dry Mixing CDG Based Geopolymer

Mechanical Properties of the Wet Mixed Geopolymer Concrete Based on CDG and Slag Cementitious Materials in Ambient Curing Temperature

Numerical analysis of flexural and shear behaviors of geopolymer concrete beams

Experimental on the Behavior of Beams Strengthened by Polymer-modified Fiber Cement Mortar Under Hydrothermal Conditions

Experimental study on performance of CFRP-strengthened RC beams with geopolymer and epoxy

Experimental Studies on the Performance of Geo-Polymer Reinforced Concrete Beams Subjected to Accelerated Corrosion

Mechanical properties and damping ratio of gradient polymer concrete for damping beam structure

Compressive Strength Performance of Geopolymer Paste Derived from Completely Decomposed Granite (cdg) and Partial Fly Ash Replacement

Interfacial Behavior of Slag, Fly Ash, and Red Mud-Based Geopolymer Mortar with Concrete Substrate: Mechanical Properties and Microstructure

Synthesis of Sustainable OPC‐Blended Geopolymer Concrete: Experimental and Modeling Study

Experimental investigations on mechanical properties of normal and high strength high calcium geopolymer concrete

Dynamic tensile properties of geopolymer concrete and fibre reinforced geopolymer concrete

An Investigation of Softening Laws and Fracture Toughness of Slag-Based Geopolymer Concrete and Mortar

Experimenting the influence of corncob ash on the mechanical strength of slag-based geopolymer concrete

Experimental investigation on the behavior of fly-ash based geopolymer reinforced concrete beams strengthened with CFRP

Fracture Properties and Softening Curves of Steel Fiber-Reinforced Slag-Based Geopolymer Mortar and Concrete

Experiment and Analysis of Mechanical Properties of Lightweight Concrete Prefabricated Building Structure Beams

Mechanical and durability analysis of geopolymer concrete incorporating bauxite residue, phosphogypsum, and ground granulated blast slag