Abstract:Abstract Abnormal discontinuous low-frequency noise occurs in the outdoor unit when the air conditioner is operating at 86~96 Hz. This noise has the characteristics of low frequency, strong penetration, long transmission distance, and poor sound quality, which can cause serious noise pollution. In order to reduce the low-frequency noise of the outdoor unit of the air conditioner, the discontinuous noise frequency is first located by testing the time-domain and frequency-domain maps of the noise. It is then compared with the frequency of fan rotation noise and structural radiation noise. It is found that the discontinuous noise is caused by the coupling of fan rotation noise and structural radiation noise. It is found that low-frequency noise improvement is significant when the frequency difference between two noise peaks is greater than 8 Hz or when a single noise peak is less than 25 dB(A) by studying the methods of frequency modulation and amplitude modulation of noise peaks. By adjusting the fan speed from 930 rpm to 940 rpm, the problem of 94 Hz noise is solved. Then, through testing the natural frequencies of the pipe and shell, it is found that the natural frequencies of the pipe are close to the excitation frequencies. The structural radiation noise is mainly caused by the pipe. Modal analysis is conducted on the pipe. When the normal boundary with the condenser and the normal boundary with the valve of the pipe is constrained by springs, the simulated values are closer to the measured values. Finally, structural optimization design is carried out on the pipe. When the U-tube of the exhaust pipe is shortened by 30 mm, a 30 g mass block is added to the cold inlet pipe, and a 97 g mass block is added to the lower part of the valve pipe of the suction pipe. The discontinuous noise of the optimized prototype is significantly improved.

Study on Noise Source Contribution of Converter Cabinet Based on Transfer Path Analysis Test

Modeling and Evaluation of Common-Mode EMI Coupling Through Converter Chassis in Metro Traction System

Research on the influence mechanism of harmonic components on the noise distribution characteristics of converter transformers

Analysis of Air Borne Noise Contribution of Transfer Paths of FR Vehicles

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

AErodynamic Noise Characteristics Of Axial Flow Fan In Narrow Space And Noise Reduction Based On Flow Control

Experiment and Simulation of Audible Noise for AC Filter Capacitor Used in Converter Station

Research on Ventilation and Noise Reduction of Indoor Substation Based on COMSOL Multiphysics

EMI Model of Air-conditioning Outdoor Machines

Numerical and Experimental Investigation of Flow Behaviour and Aerodynamic Noise in Axial Flow Fan of Air-Conditioner

Contribution Analysis of Bus Pass-by Noise Based on Dynamic Transfer Path Method

The Application of Power-Based Transfer Path Analysis to Passenger Car Structure-Borne Noise

Characterizing Noise Source and Coupling Path in Flyback Converter for Common-Mode Noise Prediction

Quantitative Evaluation of Flow-Induced Fan Casing Structural Vibration and Noise Radiation of Air-Conditioner Outdoor Unit

Cooling Module Fan Noise Simulation

Experimental And Numerical Analysis On Noise Reduction In A Multi-Blade Centrifugal Fan

TRANSFER PATH ANALYSIS AND CONTROL OF AUTOMOTIVE INTERIOR STRUCTURE-BORNE NOISE GENERATED BY A POWERPLANT

Model of Noise Source for HF Interference Calculation in a Converter Station

Test and Analysis of Cooling Fans’Non-integer Order Noises

Low-Frequency Discontinuous Noise Diagnosis and Reduction of Air Conditioner Outdoor Unit

Feasibility verification of reducing the total sound pressure level of multiple cooling fans for fuel cell vehicle