Abstract:A transmission-type attenuator with varactor-based tunable attenuation is presented. The design adopts a standard 50- $\Omega$ host microstrip line equipped with varactor-loaded stubs on its side, which also include a resistor and a capacitor in series with a short-circuit termination. The topology allows continuously tunable attenuation without interruption of the host transmission line and thus permits a compact, low-reflection, and low-loss structure for seamless planar microwave circuit integration. A generic and accurate equivalent circuit model for the proposed attenuator topology is developed for fast evolutionary optimization. To verify the circuit model, one design with three identical stubs and one with three different stubs are optimized for different performance priorities. Furthermore, two attenuators with six and nine stubs are also developed to investigate the achievable performance for different stub numbers. Prototypes of the two three-stub and the nine-stub attenuators are fabricated and tested, demonstrating a successful validation. A low reflection of less than $-11.4$ dB is achieved for all attenuators, with a measured insertion loss in the non-attenuating state of less than 1.0 dB for the three-stub attenuators and 2.1 dB for the nine-stub version, and a tunable attenuation up to 13.5 and 32.7 dB, respectively. The phase variations across the range of attenuation levels for the three-stub attenuators are less than 25.0 $^\circ$ and reach 82.3 $^\circ$ for the nine-stub design at 5 GHz. These results demonstrate a large range of tunable attenuation with a small insertion loss in the non-attenuating state, which is achieved with a compact structure suitable for seamless microwave circuit integration.

Voltage-Controlled Tunable Filtering Attenuator Using PIN Diodes

A DC-32GHz 7-Bit Passive Attenuator with Capacitive Compensation Bandwidth Extension Technique in 55 Nm CMOS

Ultra-wideband amplitude-phase compensation digital switch attenuator circuit

A DC-<i>Ka</i>-Band 7-Bit Passive Attenuator With Capacitive-Compensation-Based Bandwidth Extension Technique in 55-nm CMOS

Compact Tunable Broadband Filtering Attenuator Based on Variable Resistors

Design Of Tunable Metamaterial Absorbers Based On Pin Diodes

Design and Analysis of a Dynamically Tunable Ultra-Broadband Flexible Microwave Absorber

Design of a Low-Insertion-phase-shift MMIC Attenuator Integrated with a Serial-to-parallel Converter

Tunable Microwave Absorbers Based on Active Quasi-periodic Arrays

Electrically tunable substrate integrated waveguide equalizer based on PIN diodes

A DC-28-GHz 7-Bit High-Accuracy Digital-Step Attenuator in 55-nm CMOS

Compact Wide-Frequency Tunable Filter With Switchable Bandpass and Bandstop Frequency Response.

Continuous Resonance Tuning without Blindness by Applying Nonlinear Properties of PIN Diodes

Tunable Bandpass Filter Using a Switched Tunable Diplexer Technique.

Broadband Tunable Metamaterial Absorber with Active Lumped Diodes

AN ELECTRONICALLY TUNABLE DUAL-BAND FILTERING POWER DIVIDER WITH TUNING DIODES SHARING TECHNIQUE

Broadband Tunability of Polarization-Insensitive Absorber Based on Frequency Selective Surface

Transmission-Type Varactor-Based Tunable Attenuator

Linbo3 Based S-Bend Waveguide Variable Optical Attenuator

A Fully Tunable Filter With Wide Range Notch Frequency Tuning And Bandwidth Switchable

Tunable Multi-Tap Microwave Photonic Filter With Complex Coefficients Using A Dual-Parallel Mach-Zehnder Modulator