Abstract:The temperature dependence of the dielectric and ferroelectric properties of lead-free piezoceramics of the composition (1-x-y)Bi0.5Na0.5TiO3-xBaTiO(3)-yK(0.5)Na(0.5)NbO(3) (0.05 <= x <= 0.07, 0.01 <= y <= 0.03) was investigated. Measurements of the polarization and strain hystereses indicate a transition to predominantly antiferroelectric order when heating from room temperature to 150 degrees C, while for 150 < T < 200 degrees C both remnant polarization and coercive field increase. Frequency-dependent susceptibility measurements show that the transition is relaxorlike. For some samples, the transition temperature T-d is high enough to allow mostly ferroelectric ordering at room temperature. These samples show a drastic increase of the usable strain under an external electric field just after the transition into the antiferroelectric state at high temperatures. For the other samples, T-d is so low that they display significant antiferroelectric ordering already at room temperature. In these samples, the usable strain is relatively stable over a wide temperature range. In contrast to T-d, the temperature T-m of the transition into the paraelectric high-temperature phase depends far less on the sample composition. These results confirm that the high strain in this lead-free system is due to a field-induced antiferroelectric-ferroelectric phase transition and that this effect can be utilized in a wide temperature range. (c) 2008 American Institute of Physics.

Creep in 0.91(Na1/2bi1/2)tio3-0.06Batio3-0.03k0.5na0.5nbo3 Lead-Free Piezoceramic under Constant Electric Field Loads

Enhanced Electric-Field-induced Strain in 0.7bi(1−x)smxfeo3–0.3batio3 Lead-Free Ceramics

Piezoelectric And Strain Properties Of Ba(Ti1-Xzrx)O-3 Ceramics

Field-induced Large Strain in Lead-Free 0.99[(1−x) Bi0.5(Na0.80K0.20)0.5TiO3–xBiFeO3]–0.01(K0.5Na0.5)NbO3 Piezoelectric Ceramics

Field-induced large strain in lead-free (Bi0.5Na0.5)1−xBaxTi0.98 (Fe0.5Ta0.5)0.02O3 piezoelectric ceramics

Giant Strain in Lead-Free Piezoceramics Bi0.5Na0.5TiO3–BaTiO3–K0.5Na0.5NbO3 System

Electric Field-Induced Large Strain in Ni/Sb-co Doped (bi0.5na0.5) TiO3-Based Lead-Free Ceramics

Electric Field-Induced Large Strain in Ni/Sb-co Doped (Bi 0.5 Na 0.5 ) TiO 3 -Based Lead-Free Ceramics

Electric Field–induced Large Strain of (bi1/2na1/2)0.935ba0.065tio3–cayalo4 Lead–free Ceramics

Lead-free Piezoceramics with Giant Strain in the System Bi0.5Na0.5TiO3–BaTiO3–K0.5Na0.5NbO3. II. Temperature Dependent Properties

Giant electromechanical strain response in lead‐free SrTiO3‐doped (Bi0.5Na0.5TiO3–BaTiO3)–LiNbO3 piezoelectric ceramics

Giant Strain in Lead-Free Piezoceramics Bi[sub 0.5]na[sub 0.5]tio[sub 3]–batio[sub 3]–k[sub 0.5]na[sub 0.5]nbo[sub 3] System

Ultrahigh Strain Response with Fatigue-Free Behavior in (Bi0.5na0.5)tio3-Based Lead-Free Piezoelectric Ceramics

Strain evolution from the ferroelectric to the relaxor state in (0.67 - x)BiFeO3-0.33BaTiO3- x Bi(Mg0.5Zr0.5)O3 lead-free ceramics

Large Electric-Field-induced Strain in B-site Complex-Ion (Fe0.5nb0.5)4+-Doped Bi1/2 (na0.82k0.12)1/2tio3 Lead-Free Piezoceramics

Optimizing strain response in lead-free (Bi0.5Na0.5)TiO3-BaTiO3-NaNbO3 solid solutions via ferroelectric / (non-)ergodic relaxor phase boundary engineering

Nanoscale Ferroelectric/relaxor Composites: Origin of Large Strain in Lead–free Bi–based Incipient Piezoelectric Ceramics

High strain in Bi0.5Na0.5TiO3-based relaxors by adding two modifiers featuring with morphotropic phase boundary

Phase Transitions, Relaxor Behavior, and Large Strain Response in LiNbO3-modified Bi0.5(Na0.80K0.20)0.5TiO3 Lead-Free Piezoceramics

Normal-relaxor Ferroelectric Phase Transition Induced Morphotropic Phase Boundary Accompanied by Enhanced Piezoelectric and Electrostrain Properties in Strontium Modulated Bi0.5K0.5TiO3 Lead-Free Ceramics

Temperature‐Dependent Properties of (bi1/2na1/2)tio3–(bi1/2k1/2)tio3–srtio3 Lead‐Free Piezoceramics