Abstract:The tunneling magnetoresistance micro-sensors (TMR) developed by magnetic multilayer material has many advantages, such as high sensitivity, high frequency response, and good reliability. It is widely used in military and civil fields. This work presents a high-performance interface circuit for TMR sensors. Because of the nonlinearity of signal conversion between sensitive structure and interface circuit in feedback loop and forward path, large harmonic distortion occurs in output signal spectrum, which greatly leads to the reduction of SNDR (signal noise distortion rate). In this paper, we analyzed the main source of harmonic distortion in closed-loop detection circuit and establish an accurate harmonic distortion model in TMR micro-sensors system. Some factors are considered, including non-linear gain of operational amplifier unit, effective gain bandwidth, conversion speed, nonlinearity of analog transmission gate, and nonlinearity of polycrystalline capacitance in high-order sigma-delta system. We optimized the CMOS switch and first-stage integrator in the switched-capacitor circuit. The harmonic distortion parameter is optimally designed in the TMR sensors system, aiming at the mismatch of misalignment of front-end system, non-linearity of quantizer, non-linearity of capacitor, and non-linearity of analog switch. The digital output is attained by the interface circuit based on a low-noise front-end interface circuit and a third-order sigma-delta modulator. The digital interface circuit is implemented by 0.35μm CMOS (complementary metal oxide semiconductor) technology. The high-performance digital TMR sensors system is implemented by double chip integration and the active interface circuit area is about 3.2 × 2 mm. The TMR sensors system consumes 20 mW at a single 5 V supply voltage. The TMR sensors system can achieve a linearity of 0.3% at full scale range (±105 nT) and a resolution of 0.25 nT/Hz1/2(@1Hz).

Design of Soft Physical Unclonable Functions Based on Tunneling Magnetic ResistanceMagnetometers

Design of Interface Circuits and Lightweight PUF for TMR Sensors

A Broadband NMR Magnetometer System with Field Searching and Automatic Tuning Function

High-precision micro-displacement sensor based on tunnel magneto-resistance effect

Ultra low power fault tolerant neural inspired CMOS logic

Magnetic Interference Suppression of Tunnel Magnetoresistance Current Sensor in Power Converters

A 2 MHz Bandwidth TMR-Based Contactless Current Sensor with Ping-Pong Auto-Zeroing and SAR-Assisted Offset Calibration

Enhanced Limit-of-Detection of Current Sensor Based on Tunneling Magnetoresistive Effect With Multichips Differential Design

Assessment of functional outcomes in patients with vestibular disorders after rehabilitation.

Development and Comprehensive Evaluation of TMR Sensor-Based Magnetrodes

A physically unclonable function using NV diamond magnetometry and micromagnet arrays

Tunnel Magnetoresistance-Based Noncontact Current Sensing and Measurement Method

A 3.5MHz-BW 128nT<inf>rms</inf> Resolution TMR Readout Using Ping-Pong Auto-Zeroing and SAR-Assisted Offset Calibration for Contactless Current Sensing

A 3.5MHz-BW 128nT<sub>rms</sub> Resolution TMR Readout Using Ping-Pong Auto-Zeroing and SAR-Assisted Offset Calibration for Contactless Current Sensing

Harmonic Distortion Optimization for Sigma-Delta Modulators Interface Circuit of TMR Sensors

A Modulation Method for Tunnel Magnetoresistance Current Sensors Noise Suppression

Model and Physical Implementation of Multi-Port PUF in 65 Nm CMOS

A Reliable Physical Unclonable Function Based on Differential Charging Capacitors

Partial Discharge Diagnosis Based on TMR Magnetic Field Sensor

A Fully Digital Physical Unclonable Function Based Temperature Sensor for Secure Remote Sensing

Principle and Application of Tunnel Magnetoresistance Current Sensor Against Direct-Current Influence