Abstract:Effect of varying surface structures of the inner rotating cylinder on characteristics of droplet formed in a liquid-liquid Taylor-Couette (TC) reactor is investigated. Two novel surface structures of inner cylinders, designed with axially corrugated surface (N40) and with typical three-dimensional roughness (NZ40), respectively, were adopted for the investigation. The high-speed camera visualization was used to measure the droplet size while CFD modelling was applied to predict the fluid dynamics of TC flows with such two inner cylinders and a smooth surface inner cylinder, thus revealing the effect of inner cylinder configuration on the droplet formation in the TC flows. The experimental results have clearly indicated that both the rotation speed and surface configuration variation of the inner cylinders affect the generated droplet size and distribution. As the rotation speed increases, the droplet size is obviously reduced for all types of inner cylinder configurations. Compared with the conventional smooth surface inner cylinder, the two new types of inner cylinders with special surface structures can produce much smaller droplets, especially for the case of N40 surface structure inner cylinder, with which the smallest droplet size was found at all the experimental conditions. CFD modelling results have demonstrated that the surface configurations of inner cylinder can significantly affect the turbulence generation, consequently altering the distributions of turbulent kinetic energy and local turbulence shear strain rate. As a result, the droplet size was found to be controlled by the change of the local turbulent dissipation rate that was strongly associated with the surface structures of inner cylinders. Empirical correlations that correlate the droplet size with the Weber number and Reynolds number were proposed based on the high-speed camera visualization data.(c) 2022 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY license (http:// creativecommons.org/licenses/by/4.0/).

Measurement of Droplet Coalescence in a Mixing Tank

Study on the Numerical Model of Gas-Liquid Dispersion Driven by a Coaxial Mixer

Determination of Droplet Velocity in Square Microchannel

Effect of Inner Cylinder Configuration on Liquid Droplet Dispersion and Size Distributions in a Taylor-Couette Reactor

Inner circulation flow characteristics of coalescence droplets in microchannel

Measurement of droplet breakage in a pump-mixer

Effects of Two-Phase Periodic Velocity on Droplet Coalescence Inside Microchannels

Measurement of Internal Flow Field During Droplet Formation Process Accompanied with Mass Transfer

Mixing Efficiency Analysis On Droplet Formation Process In Microchannels By Numerical Methods

Experimental Study on Droplet Breakup in an Orifice Jet Mixer

Measurement of Interacting Ethanol Droplets Evaporation at Moderately Elevated Temperature and Pressure Using Phase Rainbow Refractometry

Effect of droplet superficial velocity on mixing efficiency in a microchannel

Millisecond Mixing of Two Liquid Streams in a Mixer Model

Using CFD and Machine Learning to Explore Chaotic Mixing in Laminar Diameter-Transformed Stirred Tanks

Experimental determination and numerical simulation of mixing time in a gas–liquid stirred tank

Influence of Dispersed-Phase Viscosity on Droplet Breakup in a Continuous Pump-Mixer

Simulations of Mixing Processes after Coalescence of Binary Momentum-Less Droplets

Particle flocculation in a stirred tank: A microscopic test by coupled CFD-DEM approach

Coalescence Law of Microdroplet Swarms in Microchannels

Investigation of Droplet Coalescence in Nanoparticle Suspensions by a Microfluidic Collision Experiment

Mixing in a co-flow-focusing structured droplet-based micromixer