Abstract:Laminar flame speeds of five cyclic hydrocarbon fuels (cyclohexane, cyclohexene, 1,3-cyclohexadiene, 1,4-cyclohexadiene, benzene) were determined with the spherically propagating flame at a wide equivalence ratio range, 403 K, two initial pressures of 0.1 MPa and 0.5 MPa. The differences among the five cyclic fuels were identified. It is found that laminar flame speeds of the five cyclic fuels all achieve their peaks around 1.1. At the same condition, laminar flame speed decreases in the order of cyclohexadiene, benzene≈cyclohexene and cyclohexane. To understand the inherent reasons causing the laminar flame speed difference, the thermal, diffusional and chemical effects were discussed. Calculation results indicate that at the same condition, the adiabatic flame temperature slightly decreases in the order of 1,4-cyclohexadiene, 1,3-cyclohexadiene, and benzene. Cyclohexene is apparently lower than benzene, while cyclohexane is much lower. The thermal diffusivity of benzene is much higher than the other fuels while that of cyclohexane is the lowest. These all contribute the fast laminar flame speeds of cyclohexadiene and benzene and the low speed of cyclohexane. It also suggests that the thermal and diffusional factors play a dominant role in causing laminar flame speed difference. Regarding chemical effect, the JetSurf 1.1 model was refined and completed. The refined model yields good performance in predicting laminar flame speeds of all cyclic fuels except benzene. To further clarify the chemical effect, a quantitative comparison was implemented among the mole fractions of combined H, O, OH in cyclohexadiene, cyclohexene and cyclohexane flames. It was found the mole fractions of H + O + OH decreases in the order of 1,4-cyclohexadiene, 1,3-cyclohexadiene, cyclohexene and cyclohexane. This result is roughly consistent with the conclusion of laminar flame speed, and could explain the different reactivities of the four cyclic fuels.

Determination of Laminar Burning Speeds and Markstein Lengths of P-Cymene/air Mixtures Using Three Models

A comprehensive experimental and kinetic modeling study of p-cymene oxidation

Comparative Research on Laminar Flame Propagation for Four C8 Fuels

Measurement of Laminar Flame Speed and Chemical Kinetic Model of 1-Pentene/air Mixtures

Flame Propagation of Mixtures of Air with High Molecular Weight Neat Hydrocarbons and Practical Jet and Diesel Fuels

Laminar flame speeds of cyclic hydrocarbon fuels: Effect of unsaturation

Laminar Flame Propagation of Atmospheric Iso-Cetane/air and Decalin/air Mixtures

Laminar Burning Velocity of 2-Methylfuran-air Mixtures at Elevated Pressures and Temperatures: Experimental and Modeling Studies

Experimental and numerical determination of laminar flame speeds: Mixtures of C2-hydrocarbons with oxygen and nitrogen

Experimental Study on Laminar Burning Speed for Anisole/Air Mixture

On the Extraction of Laminar Flame Speed and Markstein Length from Outwardly Propagating Spherical Flames

Adiabatic Laminar Burning Velocities of C3H8-O2-CO2 and C3H8-O2-N2 Mixtures at Ambient Conditions-Part I: Experimental and Numerical Study

Effect of Molecular Structure on Laminar Flame Speeds of Three C5 Alkenes

Experimental and Kinetic Study on the Laminar Premixed Cyclopentene/air Flames

Laminar Flame Characteristcs of Ethanol-Air Mixture: Experimental and Simulation Study

Experimental and Numerical Study on the Laminar Flame Characteristics for PODE3 and PODE3/iso-octane Blends under Elevated and Sub-Ambient Initial Pressures

Measurement of Laminar Flame Propagation Speed of 1-Pentene/Air Mixture

Hierarchical and Comparative Kinetic Modeling of Laminar Flame Speeds of Hydrocarbon and Oxygenated Fuels

Determination of laminar flame speeds using digital particle image velocimetry: Binary Fuel blends of ethylene, n-Butane, and toluene

Fuel similarity for laminar flames of C5 to C8 n alkanes

An Experimental and a Kinetic Modelling Study of Ethanol/Acetone/Ethyl Acetate Mixtures