Abstract:The effect of microconstituents on the corrosion and electrochemical behaviour of AZ91D alloy prepared by die-casting and ingot casting route has been investigated in 3.5% NaCl solution at pH 7.25. The experimental techniques used include constant immersion technique, in-situ corrosion monitoring, and potentiodynamic polarisation experiments. Surface examination and analytical studies were carried out using optical and scanning electron microscopy, EDX and XRD. The corrosion behaviour of microconstituents namely primary α, eutectic α and β phases was significantly different. Coring of aluminum showed influence on corrosion behaviour more significantly in ingot material. Areas with aluminium concentration less than about 8% were found to be prone to corrosion attack compared with either those with higher amount of aluminium or β phase. Die-cast material with smaller grain size and fine β phase offered marginally lower corrosion rate and better passivation compared with the ingot. In die-cast and ingot, hydrogen evolution took place preferentially on β phase. XRD pattern of non-corroded and corroded surface revealed the removal of β phase from alloy surface during corrosion. The corrosion products for ingot consisted of Mg(OH)2 with small amounts β phase, magnesium-aluminium oxide and MgH2 while for die-cast, the product showed a highly amorphous structure.

In Situ Observation of Initial Corrosion of AZ91 Alloy with Residual Stress in Wet-Dry Conditions Using Environmental Scanning Electron Microscope

In Situ Observation of Formation and Spreading of Micro-Droplets on Magnesium and Its Alloy under Cyclic Wet–dry Conditions

In Situ Observation of Pit Initiation of Passivated AZ91 Magnesium Alloy

Effect of Temperature on Initial Corrosion of AZ91 Magnesium Alloy under Cyclic Wet–dry Conditions

AC Impedance Spectroscopy Study of the Corrosion Behavior of an AZ91 Magnesium Alloy in 0.1 M Sodium Sulfate Solution

Micro-arc Oxidation Behaviors of AZ91D Magnesium Alloy in Different Electrolytes

Initial Corrosion Behavior of AZ91 Magnesium Alloy in Simulating Acid Rain under Wet-Dry Cyclic Condition

An In-Situ Degradation Behavior Study of Mao Coating on Az91d Magnesium Alloy in Aqueous Solutions by Secm

Investigation of Stress Corrosion Cracking Behaviors of an AZ91 Magnesium Alloy in 0.1 Kmol/m 3 Na2SO4 Solution Using Slow Strain Rate Test

The Corrosion Behavior of AZ91D Magnesium Alloy in Simulated Haze Aqueous Solution

Corrosion Behaviour of AZ91DSm<sub>1.0</sub> with Different Preparation Methods

Investigation of Az91d Magnesium Alloy Corrosion Behavior under Thin Electrolyte Layer Using Nondestructive Electrochemical Techniques

In Situ Observation of the Degradation Behavior and the Systematic Investigation of Corrosion Mechanism in AZ31 Alloy

Effects of Dust and Salt Particles on the Formation and Spreading of Micro-Droplets on AZ91 Magnesium Alloy

About some corrosion mechanisms of AZ91D magnesium alloy

Stress Corrosion Cracking Behaviors of Az91 Magnesium Alloy in Deicer Solutions Using Constant Load

Evaluation of microstructural effects on corrosion behaviour of AZ91D magnesium alloy

Electrochemical Noise Characteristics in Corrosion Process of Az91d Magnesium Alloy in Neutral Chloride Solution

GENERAL CORROSION AND STRESS CORROSION OF AZ91D IN TWO SALT SOLUTIONS AND AIR

Understanding the Corrosion Behavior of the AZ91D Alloy in Simulated Body Fluid through the Use of Dynamic EIS

Microstructural Evolution of Vacuum Die-Cast AZ91D Magnesium Alloy During Solution Treatment