Abstract:Dose evaluation and direct measurements are fundamental for radiation protection in non-conventional accelerator facilities, both before and after the primary and secondary shielding. In this paper, we will report about the experimental setup, data acquisition and analysis, together with FLUKA modeling, of the dose measurements test carried out in the Beam Test Facility (BTF) of the INFN - Frascati's National Laboratories (LNF), where an intense mixed field is produced and measured with thermoluminescent dosimeters. BTF is an extraction and transport line of DA Φ NE LINAC (Buonomo et al. 2021; Mazzitelli et al. 2003) . It is optimized for electrons and positrons production in a wide range of intensity, energy (30 MeV – 800 MeV), beam spot dimensions and divergence, using both primary and secondary beam of the DA Φ NE LINAC. Through the years, the BTF has gained an important role in particle detectors test and development with electron/positron beam. A small fraction of the BTF's shifts have been dedicated to radiation damage test using LINAC electron primary beam up to 5 x 1010 e-/s. As radiation protection group of the LNF, we evaluated the dose when electrons impinging on a Pb target from: i) photon Bremsstrahlung production; ii) photoneutron production. Three dedicated tests with 503 MeV electrons impinging on a ∼ 16 cm thick Pb target have been carried out in February, June 2022 and in January 2023, using TLD700 and TLD600, measuring doses at several charge intervals. The aim of this study focuses on evaluating dosimetric quantities produced by the mixed field, air kerma for the photon component, and ambient dose equivalent for the neutron one, using thermoluminescence dosimeters calibrated with low-energy standards: Cs-137 and Am-Be. The approach adopted involves the use of Monte Carlo simulations of the experiment, both to benchmark against experimental measurements and to validate the results obtained for energies higher than those of calibration. The results of this comparison show excellent agreement between measured and simulated quantities in the forward direction, allowing us to conclude and confirm the validity of the calibrations themselves.

MEASUREMENT OF PULSED NEUTRON FLUX AND DOSE EQUIVALENT RATE FOR 30mev ELECTRON LINAC

FOR A PHOTO-NEUTRON SOURCE DRIVEN BY 15 MeV ELECTRON LINAC

Measurements of Photoneutrons Produced by A 15 Mev Electron Linac for Radiography Applications

Measurement of Undesirable Neutron Spectrum in a 120 MeV Linac

Fluence and dose measurements for an accelerator neutron beam

Monitoring for Actinide Neutron Emissions From Spent Nuclear Fuel Under Extreme Gamma Fields Using Centrifugally Tensioned Metastable Fluid Detector Sensor Technology

Design of a Measurement Unit for Measuring the Neutron, Gamma Dose Equivalent Meanwhile Based on Single-sphere Multi-detector Neutron Spectrometer and GM Counter

The Research on Neutron Dose Equivalent Meter for Pulse Neutron Radiation Field

AMBIENT DOSE EQUIVALENT RECEIVED AT 15 MV LINAC ENVIRONMENTS DUE TO PHOTONEUTRONS CONTAMINATION

Neutron Measurements from Beam-Target Reactions at the Elise Neutral Beam Test Facility

Thermal neutron detection and track recognition method in reference and out-of-field radiotherapy FLASH electron fields using Timepix3 detectors

A Modified Neutron Dose-Equivalent Meter for Pulsed Neutron Radiation Field

Measurement of the Gamma-Ray Sensitivity and Signal-to-noise Ratio of a New Scattered-Electron Detector

Photon and neutron dose evaluation at the beam test facility of the INFN - National laboratory of Frascati

Cross-section Measurements for the Reactions of 14 MeV Neutrons on Indium Isotopes.

Neutron Dose Measurement in Carbon Ion Radiation Therapy at HIRFL (IMP)

Induced radioactivity analysis for the NSRL Linac in China using Monte Carlo simulations and gamma-spectroscopy

Monitoring the Energy Variation of an Electron Linac Using a Cerenkov Detector

Neutron Dose measurement in the carbon ion therapy area at HIRFL (IMP) as 12C ions with energies from 165 to 350MeV/u

Full Geant4 and FLUKA Simulations of an e-LINAC for its Use in Particle Detectors Performance Tests

Very-High-Energy Heavy Ion Beam Dosimetry using Solid State Detectors for Electronics Testing