Abstract:In this study, PVDF/PTFE composite membranes were prepared by adding a PTFE nanoemulsion to a PVDF solution and casting it through the conventional non-solvent-induced phase separation method. The objective was to explore the effectiveness of using a simple and economical method to modify PVDF membranes with PTFE to enhance their anticorrosion performance, especially under highly acidic or alkaline conditions. PTFE nanoparticles (of around 200 nm in size) in nanoemulsion form were blended with PVDF at a mass ratio of PTFE:PVDF in the range of 0–0.3:1. The obtained membranes were examined to determine the effect of the added PTFE nanoparticles on the structure of the modified PVDF membranes as well as on their mechanical strength and surface characteristics. The membranes were then immersed in various concentrations of acidic or alkaline solutions for varied durations ranging from a few days up to as long as 180 days (6 months). The impacts of by the corrosive solutions on the tensile strength, surface roughness, and water flux of the membranes with different exposure times were quantified. The results showed that although a certain extent of change may occur with extended immersion times, greatly enhanced anticorrosion performance was obtained with the prepared PVDF/PTFE membranes compared with the unmodified PVDF membrane. For example, after being immersed in 5 mol-H+··L−1 H2SO4, HCl, and HNO3 solutions for 6 months, the tensile strength at breaking point remained at up to 69.70, 74.07, and 71.38%, respectively, of the initial strength for the PVDF/PTFE (M30) membrane. This was in contrast to values of only 55.77, 70.43, and 61.78% for the unmodified PVDF membrane (M0). Although the water flux and surface roughness showed a change trends to the tensile strength, the PVDF/PTFE (M30) membrane had much higher stability than the PVDF (M0) membrane. In a continuous filtration experiment containing H2SO4 at 0.01 mol-H+·L−1 for 336 h (14 days), the PVDF/PTFE membrane showed a maximum flux change of less than 30%. This was in comparison with a change of up to 50% for the PVDF membrane. However, the PVDF/PTFE membranes did not seem to have a greatly enhanced anticorrosion performance in the alkaline solution environment tested.

Comparison of PVDF Porous Membranes Modified by Two Different Methods Using Composite Nano-Particles

Influence of polyvinyl alcohol on the surface morphology, separation and anti-fouling performance of the composite polyamide nanofiltration membranes

Modification of Porous Poly(Vinylidene Fluoride) Membrane Using Amphiphilic Polymers with Different Structures in Phase Inversion Process

Hydrophilic Modified Polydopamine Tailored Heterogeneous Polyamide in Thin-Film Nanocomposite Membranes for Enhanced Separation Performance and Anti-Fouling Properties

Effect of nano-sized Al2O3-particle addition on PVDF ultrafiltration membrane performance

Effect of TiO2 modified layer thickness on the properties of PVDF-TiO2 membrane

Novel polysulfone hybrid ultrafiltration membrane prepared with TiO2-g-HEMA and its antifouling characteristics

Preparation and Characterization of an Amphiphilic Polyamide Nanofiltration Membrane with Improved Antifouling Properties by Two-Step Surface Modification Method

Preparation of Nano-TiO2-Modified PVDF Membranes with Enhanced Antifouling Behaviors via Phase Inversion: Implications of Nanoparticle Dispersion Status in Casting Solutions

Developing PVDF Hollow Fiber Membrane Enhanced by Braided Tube and Modified by Bionic Coating for Treating Aldehyde-Containing Wastewater

Anti-fouling membranes by manipulating surface wettability and their anti-fouling mechanism

Effects of solvent compositions on physicochemical properties and anti-fouling ability of PVDF microfiltration membranes for wastewater treatment

A Facile Approach to Fabrication of Superhydrophilic Ultrafiltration Membranes with Surface-Tailored Nanoparticles

Significantly enhanced antifouling and separation capabilities of PVDF membrane by synergy of semi-interpenetrating polymer and TiO2 gel nanoparticles

Anti-Fouling Performance of Mixed Matrix PVDF Membranes with Mono-Hydroxyl Poly(dimethylsiloxane) (PDMS-OH) Grafted Silica Nanoparticles

An Investigation on the Antifouling Ability of Pvdf Membranes by Polydopa Coating

Effects of the Addition of Nano-Sized SiO2 on the Structure and Performance of PVDF/SiO2ultrafiltration Membrane

Antifouling modification of PVDF membranes via in situ mixed-charge copolymerization and TiO2 mineralization

Anticorrosion Performance of PVDF Membranes Modified by Blending PTFE Nanoemulsion and Prepared through Usual Non-Solvent-Induced Phase Inversion Method

Surface Modification of Poly(vinylidene fluoride) Ultrafiltration Membranes with Chitosan for Anti-Fouling and Antibacterial Performance

Inner Surface Hydrophilic Modification of PVDF Membrane with Tea Polyphenols/Silica Composite Coating