Abstract:The indirect tensile test plays a crucial role in experimental investigations of brittle material properties. In this study, a mechanical analysis model of the rectangular test block is established based on the theory of elastic mechanics for the characteristics of the indirect tensile test. The theoretical solution of the triangular series is derived for the rectangular test block under the locally distributed load. The finite element simulation results and splitting test results were compared with the theoretical results. The results of the study verify the accuracy of the theoretical solutions. Based on the proposed analytical solution, the effects of loading width and length-to-height ratio (h/l) of local loading on the measured tensile strength of test block are discussed. The results demonstrate that the tensile strength of the test block increases as the loading width expands, and the rate of growth in the recorded tensile strength gradually stabilizes. The variation in loading width affects the location of crack initiation points during the concrete test block splitting tests. When the loading width exceeds 6% of the side length of test block, the cracking point is positioned at the center of test block, ensuring the effectiveness of the splitting test. As the length-to-height ratio of the test block increases, there is a general upward trend in the measured tensile strength. When h/l 0.6, the measured tensile strength consistently increases, with the rate of increase gradually diminishing until it stabilizes. The length-to-height ratio also significantly influences the location of the cracking point in the test block. As the length-to-height ratio increases, the cracking point initially shifts from around the center to the central point and then further from the center toward the edge. To ensure that the location of the crack initiation point is in the center of the specimen and that the tensile strength is close to the measured result, the length to height ratio can be chosen at around 0.85.

Establishing Curve for Measuring Strength to Detect Compression Strength with Resilience Method for Ningxia Municipality

Experimental research on the strength of concrete mearsured by limpet

Experimental Research On Solidification Of Ningbo Soil With Its Different Initial Status

Mesoscopic numerical test of crushing process of concrete under uniaxial compression

Rheological Test and Empirical Model of Ningbo Soft Soil

Mechanical and Microstructure Characterization of Fresh High- and Normal- Strength Concrete with Non-Contact Electrical Resistivity Measurement

A concrete quality control in the construction process

Experimental Research on Concrete Strength Prediction by Limpet Pull-off Test in China

Study on the Strength of Expansive Soil Based on Water Content and Dry Wet Cycle

Experimental Study and Analytical Formulation of Mechanical Behavior of Concrete

An Inverse Analysis Method for Determining Tensile Softening Relationship of Concrete Considering Local Response

Comparison of Evaluation Tests for Compressive Strength of Structural Concrete

A New Experimental Method of Concrete Complete Direct Tensile Stress-strain Curve

EXPERIMENTAL STUDY OF THE DETECTING METHOD FOR COMPRESSIVE STRENGTH OF NON-STANDARD CONCRETE HOLLOW BLOCK

Field test and analysis of controlling metro excavations deformation by foundation reinforcement

Measurement and Modeling of Creep Property of High-Strength Concrete Considering Stress Relaxation Effect

Theoretical Investigation on Indirect Tensile Strength of Concrete with Rectangular Cross-Section under Locally Distributed Load

A PRELIMINARY RESEARCH ON USING CORE RING METHOD TO MEASURE RESIDUAL STRESS IN CONCRETE PAVEMENT SURFACE

Experimental Study of Uniaxial Compression Properties of High Performance Fine Grained Concrete

A Contrast Experimental Study of C40 Concrete Tensile Strength

The research on the check experiment of resilience performance curve of component