Abstract:In a low-voltage electric distribution network, arc fault presents a high energy density electricity-discharging phenomenon between conductors, which is often caused by aging of electric facilities, loose contacts and terminals, or insulation failure due to internal and external destructions. A large amount of heat may be created during this discharging, which will further cause the risk of fire hazards to mitigate in the residential environment. Currently, many utility grid operators and electricity users are still devoted to seeking effective detection technology for arc fault protection. This paper proposes a hybrid approach that combines discrete wavelet transform (DWT), empirical mode decomposition (EMD), and dynamic time warping (DTW) methods for low-voltage AC series arc fault detection. In DWT, it uses time–frequency domain characteristics of the arc current signal to extract the occurrence of arc fault. In EMD, it decomposes the complex arc fault current signal into a finite intrinsic mode (IMF) signal; then, instantaneous amplitude of IMF signal is obtained by Hilbert–Huang transform (HHT) as a feature for arc fault identification. Firstly, the results of arc fault detections depend on the results from DWT and EMD. When both two methods detect different results, DTW method will be activated, using the similarity measurements between normal and arc fault current waveforms as an assistant measure to determine the occurrence of arc fault. The performance of the proposed approach is tested and validated using various electric appliances, and the results show that the proposed approach can effectively detect low-voltage AC series arc fault.

Principle and Application of Low-voltage Busbar Introducing Intelligent Ultrasonic Atresia Arc Protection

Design of New Arc Protection Device

Design & Implementation Of An A-Type Residual Current Circuit Breaker Ic

Analysis of Arc Characteristics and Fault Detection in Low Voltage DC System

Design And Test Of Unified Power Flow Controller Protection Circuits

Research and Analysis on Low Voltage Arc Fault

Review of Research on DC Arc Fault Detection Technology in Low Voltage DC System

A Method for Parallel Arc Fault Detection and Identification

A Method For Residential Series Arc Fault Detection And Identification

Research Progress on Air Arc of Low Voltage Electrical Appliances

DC Arc Fault Detection Method Based on K-line and Spectrum Integration Difference of Current

Experimental Study and Feature Improvement of DC Series Arc Faults with Switching Noise Interference

Development of Arc-Guided Protection Devices Against Lightning Breakage of Covered Conductors on Distribution Lines

A New Principle of Active Arc Suppression for Distribution Network Based on Constant Fault Phase Current

Hardware Implementation of Series Arc Fault Detection Algorithm for Different DC Resistive Systems

Research on AC Arc Fault Characteristics Based on the Difference Between Adjacent Current Cycle

Serial Arc-Fault Restriction Survey with Standard-listed Products in the Chinese Market

Study on characteristics and detection of DC arc fault in power electronics system

An Active Voltage-Type Grounding Fault Protection Method for Medium-Voltage Distribution Networks with Neutral Point Voltage Flexible Regulation

Design of Fault Arc Detection Device Based on STM32

A Hybrid Approach for Low-Voltage AC Series Arc Fault Detection