Abstract:Recovering gold from wastewater has both economic and environmental benefits. However, how to effectively recover it is challenging. In this work, a novel Fe-based metal-organic framework (MOF) was synthesized and decorated with 2,5-thiophenedicarboxylic acid to have a well-developed porous architecture to effectively recover Au(III) from water. The maximum Au(III) sorption capacity by the finally-synthesized porous material MIL-101(Fe)-TDCA reached 2350 mg/g at pH = 6.00 ± 0.15, which is one of the highest among all literature-reported relevant materials including MOFs, and high sorption strength can be maintained within a wide pH range from 2.0 to 10.0. Besides, Au(III) sorption efficiency at low concentrations (i.e., 3.5 × 10−4 mg/mL) reached over 99 %. Mechanically, outstanding Au(III) sorption by MIL-101(Fe)-TDCA resulted from the O/N/S-containing moieties on its surface, large surface area and porosity. The N- and S-containing functionalities (CS, CONH) served as electron donors to chelate Au(III). The O-containing (FeOFe, COFe, COOH, and coordinated H2O) and N-containing (CONH) moieties on MIL-101(Fe)-TDCA interacted with OH groups on the hydrolyzed species of Au(III) (AuCl3(OH)−, AuCl2(OH)2−, and AuCl(OH)3−) by hydrogen bond, which further increased Au(III) sorption. Furthermore, about 45.71 % of Au(III) was reduced to gold nanoparticles by CS groups on the decorated 2,5-dithiophene dicarboxylic acid during sorption on MIL-101(Fe)-TDCA. Over 98.35 % of Au(III) was selectively sorbed on MIL-101(Fe)-TDCA at pH 4.0, much higher than that of the coexisting heavy metal ions including Cu(II), Zn(II), Pb(II), and Ni(II) (<5 %), despite their same concentration at 0.01 mg/mL. Although sorption selectivity of a noble metal Pt(IV) by MIL-101(Fe)-TDCA is relatively poor (68.23 %), it could be acceptable. Moreover, reusability of MIL-101(Fe)-TDCA is also excellent, since above 90.5 % Au(III) still can be sorbed after two sorption-desorption cycles. Overall, excellent sorption performance and the roughly-calculated gold recycling benefits (26.30 %) highlight that MIL-101(Fe)-TDCA is a promising porous material for gold recovery from the aqueous phase.

Efficient Gold (au)(iii) Recovery from Wastewater Using a Mercapto-1,3,4-thiodiazole Modified Zn-MOF

Selective recovery of gold ions in aqueous solutions by a novel trithiocyanuric-Zr based MOFs adsorbent

Selective Removal Mechanism of the Novel Zr-based Metal Organic Framework Adsorbents for Gold Ions from Aqueous Solutions

MIL-161 Metal–Organic Framework for Efficient Au(III) Recovery from Secondary Resources: Performance, Mechanism, and DFT Calculations

Dual thiols-decorated metal–organic framework for efficient separation and recovery of gold

Efficient recovery of gold using Macroporous Metal-Organic framework prepared by the 'MOF in MOF' method

An O/N/S-rich porous Fe-based metal-organic framework (MOF) for gold recovery from the aqueous phase with excellent performance

Regulating the Interface Polarity Distribution of Zr-Based MOFs by Amino Acid-Like Ligand Functionalization Enables Efficient Recovery of Gold.

External optimization of Zr-MOF with mercaptosuccinic acid for efficient recovery of gold from solution: Adsorption performance and DFT calculation

Efficient and Selective Recovery of Au(III) from Aqueous Solution by Functionalized UiO-67 Materials: Cooperative Effects of Diamino-Functionalization and Charge Modulation

Highly selective and effective gold recovery from electronic wastewater by synergistic effect between covalent organic framework (COF) and MoS 2 : Performance and mechanisms

Efficient gold capture from wastewater by NH 2 -MIL-125 and its application for photocatalysis: A turning waste into treasure approach

The design of high-efficient MOFs for selective Ag(I) capture: DFT calculations and practical applications

Highly efficient gold recovery from electronic waste through employing 3D printed Polyethylenimine/graphene oxide/calcium alginate multilevel Macroporous adsorbent

Selective and highly efficient recovery of Au(III) by poly(ethylene sulfide)-functionalized UiO-66-NH2: Characterization and mechanisms

Engineering Hydroxyls on a Metal-Organic Framework As Adsorbers and High-Activity Dehydrochlorination Sites for Selective Gold Recovery

Zr 4+ -mercaptosuccinate MOF for the uptake and recovery of gold nanoparticles and gold ions under batch and continuous flow conditions

A MOF/poly(thioctic acid) composite for enhanced gold extraction from water matrices

Efficient and Selective Gold Recovery from E-Waste by Simple and Easily Synthesized Covalent Organic Framework

Highly Efficient Recovery of Au(I) from Gold Leaching Solution Using Sodium Dimethyldithiocarbamate

Efficient environmental recovery of Au(I) from thiosulfate solution on triphenylphosphine-oxide-modified vermiculite