Abstract:This article presents the results of the theoretical and experimental studies of frequency tuning in the -band low-voltage magnetron with two energy outputs. The principal condition of applying the magnetron is the application of the short-circuit piston as a reactive load of the second (passive) energy output. For theoretical investigation, we used two mathematical models of the magnetron: the simple analytical model for simulation of the "cold" anode block in one-wave approximation using the equivalent circuit method and the 3-D model of the magnetron using the particle-in-cell (PIC) method. It is shown that the necessary condition for frequency tuning in such magnetrons is a request to design the anode block when the coupling of the passive RF output with the anode block exceeds the analogous coupling between the anode block and the active RF output. The numerical experiment shows the more complicated nonlinear mechanism for limiting the frequency tuning band. It has been found that a reason for such limitation is conditioned by competition of operating -mode with the closest in the frequency of additionally excited resonant high- and low-frequency -modes. For the experimental investigation, we used the prototype of the magnetron having the following operating parameters: the central frequency is 9.38 GHz, the anode voltages are V, the axial magnetic field is 0.21 T, the indirect heater cathode and the forced-air cooling. As a result, at maximum output power of ~18 W and efficiency of ~37%, the frequency tuning full range was ~320 MHz.

Comparison of Excitation Voltage-Waveforms for Millimeter-Wave Magnetron

3d Particle-In-Cell Simulation Of Continuous Wave Magnetron

Simulation and Experiment Measurement of High Power Continuous Wave Magnetron

3d Particle-In-Cell Simulation Of S Band High Power Continuous Wave Magnetron

Modeling and Experiments of an Injection-Locked Magnetron With Various Load Reflection Levels

A Magnetron Using an Additional External Reactive Load for Frequency Tuning: Theory Features and Experiment

Design of a Simultaneous Information and Power Transfer System Based on a Modulating Feature of Magnetron

Study of a THz Spatial Harmonic Magnetron

Experimental Study of Magnetron's Power-Pulled Characteristic to Realize a Quasi-Dual-Frequency Microwave Output

Development of a 1497-Mhz, 13.5-Kw Continuous- Wave Magnetron for Superconducting Radio Frequency Accelerator

A Method of Tuning Frequency in S -Band Continuous-Wave Magnetron

Extracting millimeter-wavelength radio emission from a relativistic magnetron

Design of High Performance Magnetron Power Supply on the Basis of PWM Power Control

Modeling and optimization of a relativistic magnetron with transparent cathode and output mode

Equivalent Circuit Method of Π-Mode Frequency of Rising-Sun Magnetron

Comprehensive Particle-In-Cell Simulations of Ten-Vane Microwave Oven Free-Running 2.45 GHz “Cooker” Magnetron With ICEPIC and CST-PS Codes

Theoretical investigation of frequency characteristics of free oscillation and injection-locked magnetrons*

PIC Simulation of the Coaxial Magnetron for Low Energy X-band Linear Accelerators

Theoretical Investigation of Resonant Frequencies of Unstrapped Magnetron with Arbitrary Side Resonators

The Interlocking Experiment on Millimeter Wave Coaxial Magnetron for Array Application

Sweep Frequency Heating based on Injection Locked Magnetron