Abstract:Transmission with few-mode fiber (FMF) is one of the most promising methods for increasing single fiber capacity, with urgent demands for low-noise and wideband amplification. In this work, we experimentally demonstrate a few-mode hybrid Raman amplifier (FM-HRA) based on a second-order few-mode distributed Raman amplifier (FM-DRA) cascaded with a lumped Raman amplifier (LRA). The few-mode hybrid amplification with a 100-nm bandwidth (1520 to 1620 nm), covering the S + C + L bands, is realized using a weakly-coupled FMF with a transmission length of 100 km and a dispersion compensating fiber (DCF). The maximum on-off gains for three modes (LP01, LP11, and LP21) are 22.6, 25.1, and 25.5 dB, and the average on-off gains over 100-nm bandwidth are 19.6, 21.4, and 21.3 dB, respectively. The differential modal gain (DMG) is less than 2.9 dB. The effective noise figure (NF) of the three modes is lower than −1.1 dB over 100-nm bandwidth, and the lowest effective NF is −6.8 dB, which is close to the effective NF of FM-DRA. This means HRA can fully utilize the advantages of ultralow noise of DRA and high gain of LRA. The MIMO-less transmission experiment demonstrates the highest data rate of 56 Gbps for LP01 mode. This work features pure Raman amplification with high gain, ultralow noise, and wideband. The configuration of high-order DRA in FMF and first-order LRA in DCF also offers the benefits of better pump power utilization and dispersion compensation.

130 nm SCL-wideband and -7.1 dB effective-noise-figure amplification using third-order distributed Raman amplifier

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

A Flattening Gain Raman Amplifier Involved Only 2 Cascaded FBG Based Multi-Wavelength Pumps

Ultralow Noise and SCL Wideband Few-Mode Amplification and Transmission Based on Second-Order Few-Mode Distributed Raman and First-Order Single-Mode Lumped Raman

Ultralow Noise C + L Wideband WDM-IMDD Transmission at 18 × 112 Gbps by Using Hybrid Second-Order Distributed Raman and First-Order Lumped Raman Amplification.

High Gain, Low Noise, Spectral-Gain-Controlled, Broadband Lumped Fiber Raman Amplifier

Experimental Demonstration of a Few-Mode Raman Amplifier with a Flat Gain Covering 1530-1605 Nm.

Ultra-Low-Noise Mode-Division Multiplexed WDM Transmission over 100-Km FMF Based on a Second-Order Few-Mode Raman Amplifier

High-order few-mode-fiber Raman amplifier for low noise mode-division-multiplexed optical communication

Second-order Few-Mode Raman Amplifier for Mode-Division Multiplexed Optical Communication Systems.

Multi-band programmable gain Raman amplifier

Second-Order Few-Mode Distributed Raman Amplifier for Mode-Division Multiplexing Transmission

Nanosecond pulse pumped, fiber-integrated narrow linewidth linearly polarized Raman amplifier at 1120 nm

Narrow Line-Width 1653 nm Raman Fiber Amplifiers

Continuous-wave Raman amplification in silicon core fibers pumped in the telecom band

C + L Band Distributed Few-mode Raman Amplification with Flattened Gain for Mode-division-multiplexed Optical Transmission over 75-Km Few-mode Fiber

Low-noise Figure C+L-band EDFA with a Preamplifier and an Improved Double-Pass L-band Amplifier

3 Kw Narrow-Linewidth All-Fiber Amplifier with Near Diffraction Limited Beam Quality

Experimental Demonstration of Output Power Spectrum Clamping for Multi-Channel Backward-Pumped Distributed Fiber Raman Amplifiers

First Demonstration of Second-Order Few-Mode Raman Amplified Ultra-Low-noise Transmission of WDM/MDM QPSK Signals over 100-Km FMF

C Band Single Pump Photonic Crystal Fiber Raman Amplifier