Abstract:Abstract The receiver is a signal receiving device placed at the focus of the telescope. In order to improve the observation efficiency, the concept of phased array receiver has been proposed in recent years, which places a small phased array at the focal plane of the reflector, and flexible pattern and beam scanning functions can be achieved through a beamforming network. If combined with the element multiplexing, all beams within the entire field of view can be observed simultaneously to achieve continuous sky coverage. This article focuses on the front-end array of phased array receiver at 0.7-1.8 GHz for QiTai Telescope, and designs a Vivaldi antenna array of PCB structure with dual line polarization. Each polarization antenna is designed to arrange in a rectangle manner by 11 × 10. Based on the simulation results of the focal field, 32, 18 and 8 elements were selected to form one beam at 0.7, 1.25 and 1.8 GHz. A analog beamforming network was constructed, and the measured gains of axial beam under uniform weighting were 19.32, 13.72 and 15.22 dBi. Combining the beam scanning method of reflector antenna, the pattern test of different position element sets required for PAF beam scanning was carried out under independent array. The pattern optimization at 1.25 GHz was carried out by weighting method of conjugate field matching. Compared with uniform weighting, the gain, sidelobe level, and main beam direction under conjugate field matching have been improved. Although the above test and simulation results are slightly different, which is related to the passive array and laboratory testing condition, the relevant work has accumulated experience in the development of front-end array for phased array receiver, and has good guiding significance for future performance verification after the array is installed on the telescope.

Design of a Wideband Transmitarray Phaser Using Vivaldi Antenna for Dispersive Delay Radiation

An 800-Ps Origami True-Time-Delay-Based CMOS Receiver Front End for 6.5–9-Ghz Phased Arrays

An Ultra Broadband Passive Vector Modulator Phase Shifter

An mmWave FZP-Based Phased Array

A 94 GHz Slot Array Fed by a WR10 Interface

Design of an electronically steerable dielectric helical antenna phased array for millimeter wave applications

A Wideband Transmitarray Using Triple-Layer Elements Combined with Cross Slots and Double Square Rings

Low-Scattering X-Band Planar Phased Vivaldi Array Antenna

An antipodal Vivaldi antenna for improved far-field properties and polarization manipulation of broadband terahertz quantum cascade lasers

2-Bit Wideband Electronically Controlled Reconfigurable Phased Array with Wide-Angle Beam-Scanning Capacity

Design of a Wideband Reconfigurable Transmitarrray Element Using a Novel Phase Shifter with Varactors and PIN Diodes

Development of a Front End Array for Broadband Phased Array Receiver

Design and Implementation of a Wideband 1-Bit Transmitarray Based on a Yagi-Vivaldi Unit Cell

140 GHz High-Gain LTCC-Integrated Transmit-Array Antenna Using a Wideband SIW Aperture-Coupling Phase Delay Structure

High-Gain UWB Vivaldi Antenna Loaded With Reconfigurable 3-D Phase Adjusting Unit Lens

A Wideband Circularly Polarized Vivaldi Array Antenna with Axial Ratio Enhancement

Ultra-Wideband Coplanar Vivaldi Antenna Array With Dielectric Patch Antenna for Grating Lobes Suppression

Dual-Polarized Metal Vivaldi Array Using Independent Structural Elements

A novel high-gain antipodal vivaldi antenna for 5G MM-wave applications

A 27-to-31.6 GHz 8-Element Phased-Array Transmitter Front-End with Inter-Element-Interference Cancellation Scheme in 65 Nm CMOS

A microfabricated low-profile wideband antenna array for terahertz communications