A 16.5-μW 73.7-dB-SNDR Second-Order Fully Passive Noise-Shaping SAR ADC With a Hybrid Switching Procedure
Zheng Li,Yating Yang,Mingyang Liu,Wei Liu,Ying Hou,Zihui Wei,Xiaosong Wang,Zhenming Li,Shuilong Huang,Yu Liu
DOI: https://doi.org/10.1109/access.2023.3305571
IF: 3.9
2023-08-29
IEEE Access
Abstract:Noise-shaping (NS) successive approximation register (SAR) analog-to-digital converters (ADCs) using passive integrators have drawn increasing attention owing to their simplicity and power efficiency. However, a capacitor array with a passive integrator result in a huge number of unit capacitors and power consumption. This paper presents a second-order fully passive NS-SAR ADC with a segmented capacitor array and a hybrid switching procedure. We use a most-significant-bit(MSB) sampling-segmented capacitor array to reduce the number of unit capacitors, and a common mode voltage(VCM)-based hybrid switching procedure to reduce the average switching power. Compared to fully passive NS-SAR ADCs with conventional capacitor array and switching procedure, the total number of unit capacitors is reduced by about 84%, and the average switching power is also reduced by about 97.8%. The prototype was fabricated using 180nm complementary metal oxide semiconductor(CMOS) technology, it only uses 478 unit capacitors, resulting in an area of 0.086 mm2. It consumes , achieves 73.7 dB peak signal-to-noise-and-distortion ratio(SNDR), and a Schreier figure of merit(FoMs) of 165.5 dB.
computer science, information systems,telecommunications,engineering, electrical & electronic