Optimal Design and Off-Design Performance Improvement for Power-to-methane System Integrating Solid Oxide Electrolysis Cell with Methanation Reactor

Like Zhong,Xiaoti Cui,Erren Yao,Guang Xi,Hansen Zou,Soren Hojgaard Jensen
DOI: https://doi.org/10.1016/j.fuel.2023.129314
IF: 7.4
2024-01-01
Fuel
Abstract:Power-to-methane (PtM) is a prospective solution to the mismatching between the supply and consumption of renewable energy resources (RES) by converting renewable power into methane. However, the continuous fluctuation of RES causes the PtM system to deviate from the design condition in the vast majority of cases, and thus it is significantly vital to study the operating characteristics of the PtM system under off-design conditions. This paper proposes a comprehensive investigation framework from design to off-design steps for the performance improvement of a PtM system combining solid oxide electrolysis cell with methanation reactor, and solar energy is selected as renewable energy input. Firstly, the system with the total exergy efficiency (& eta;EX,tot) of 11.83% and levelized cost of exergy (LCOE) of 150.76 $/MWh is selected as the optimal design condition based on the homogeneous assessment from both thermodynamic and economic aspects, by means of Non-dominated sorting genetic algorithm-II. Then, based on the optimal design point, the off-design performances are quantitatively investigated under varying solar radiation and key operating parameters, in terms of synthetic natural gas (SNG) yield and & eta;EX,tot. The results indicate that with the increment in solar radiation, the SNG yield rises, while the & eta;EX,tot increases first and then decreases. Finally, the multi-objective optimization based on the Artificial Neural Network models is implemented for the system under off-design conditions to acquire the best tradeoff between hourly SNG yield and & eta;EX,tot. The off-design optimization solutions reveal that the hourly optimal SNG yield is located in the range of 275.06-946.53 kW, achieving a total annual SNG yield of 1697 MWh/y, and the hourly optimal & eta;EX,tot mainly varies in the range of 10.40-11.40%.
What problem does this paper attempt to address?