Abstract:Traditionally, circular orifices have been used for generating aerosols, however in recent times non-circular orifices are being considered due to their superior atomization and mixing features. In this work, we experimentally investigate spray morphology and drop size characteristics of kerosene (Jet A-1) jets issuing from three non-circular orifices geometries (elliptic, triangular and, square) and one circular orifice with the same exit cross sectional area. Our results show an unexpected and yet unreported coarsening of atomization for non-circular orifice jets quantified by an increase in the Sauter Mean Diameter (SMD) at all tested exit velocities represented by the liquid Weber number, $We_l$. We attribute this to two distinct spray morphologies: filament and core breakup which generate large size liquid structures identified as filaments and ligaments, noticeable in non-circular orifices jets compared to circular orifice jets. On exploring this further by undertaking an examination of the drop size volume probability distribution at lower $We_l$ corresponding to the location marking the end of primary breakup we see a bimodality due to a dominant distribution of fragments of small and larger sizes owing to the spray morphology. At higher $We_l$ and larger distances from the injector exit we observe the bimodality converts to a unimodal distribution for all orifice jets with a single peak situated at lower drop diameters. Filament breakup is reasoned to be the cause of higher number of smaller drop sizes in triangular sprays among all non-circular orifice jets while thinner filaments in circular orifice sprays lead to smaller drop sizes compared to their triangular counterparts showing the same breakup morphology. We expect our results to help applications as diverse as engine fuel combustion, pharmaceutical sprays and CO$_2$ capture by NaOH sprays.

Influence of surface and edge profile of a spinning disc on its atomization characteristics in direct drop mode

Droplet size distribution in a swirl airstream using in-line holography technique

Surface-Controlled Shape Design of Discotic Micro-Particles

Computational study of free surface film flow and subsequent disintegration of a sheet and ligaments into droplets from a rotary disk atomizer

Controlled Micro–Nano-Scale Droplet Generation via Spin Dewetting

Experimental Study on the Critical Characteristics of Liquid Atomization by a Spinning Disk

Effect of the surface peak-valley features on droplet splash dynamics

Drop spreading dynamics with a liquid needle drop deposition technique

Predicting the Splash of a Drop Impacting a Thin Liquid Film

Changing the flow profile and resulting drying pattern of dispersion droplets via contact angle modification

Offset coalescence behaviour of impacting low-surface tension droplet on high-surface-tension droplet

Critical breakup transition characteristics of thin viscose liquid film at spinning disk rim

The Influence of Geometric Boundary Features on Droplet Wetting and Directional Motion

Drop size characteristics of sprays emanating from circular and non-circular orifices in the atomization regime

An experimental investigation of droplet morphology in swirl flow

Spinning disk atomization: Theory of the ligament regime

Experimental Insights into Droplet Behavior on Van der Waals and Non-Van der Waals Liquid-Impregnated Surfaces

How Microstructures Affect Air Film Dynamics Prior to Drop Impact

Spreading and retraction of the concentric impact of a drop with a sessile drop of the same liquid: Effect of surface wettability

Stable Droplet Manipulation in Multiple Directions on a Magnetically Responsive Micropillar Array Surface

Impact dynamics and solidification behaviour of a molten droplet on a flat surface at different Weber numbers