Abstract:Indirect method to identify dynamic properties of bridge by a passing vehicle is attractive recently since it does not require pre-installed sensors on bridge. However, the extracted dynamic properties are not accurate enough to identify local damages due to road surface roughness. To overcome this issue, a method to identify mode shapes and detect local damages in a simply supported bridge by movable sensory system is proposed in this study. Instead of using passing vehicles, two stationary vehicles are adopted in this study to perform as movable sensory system. They stay stationary at two different locations on the bridge subject to ambient environmental excitation, and their vertical accelerations are collected to calculate the vertical displacement of the two contact points between vehicles and bridge. Then they move to another two locations and the same procedures are repeated. After all locations along the bridge are tested, a matrix similar to frequency response matrix can be constructed and SVD method is used to extract the mode shapes. The element stiffness is thereafter evaluated by the fundamental mode shape, which can be then used to detect local stiffness reduction in the bridge. Numerical study has been conducted to validate the proposed method, and the effect of bridge damping, vehicle damping, measurement noise, and traffic flow is investigated. Moreover, field testing was conducted on Li-Zi-Wan Bridge and the results showed that the proposed method can re-construct the mode shapes and evaluate element bending stiffness as accurately as conventional direct approach. The proposed method is convenient and easy to implement in practice; and it is more robust because it is not affected by road surface roughness.

Mechanism of the Passive Tap-Scan Damage Detection Method

The tap-scan method for damage detection of bridge structures

On the Tapping-Scan Method Designed for the Damage Detection of Bridge Structures

Detect the Stiffness Transition in Beam Structures by Using the Passive Tap-Scan Method

Damage Identification in Warren Truss Bridges by Two Different Time–Frequency Algorithms

Damage Detection for Continuous Beams by Using the Tap-Scan Method

Vibration-Based Damage Detection Of Cable-Stayed Bridges

Bridge damage identification with improved HHT and PSD sensitivity method based on vehicle response

Mode Shape Identification and Damage Detection of Bridge by Movable Sensory System

Damage Identification Analysis of Bridge Beam with Spaced Supports As Quasi-Periodic Structure

Damage Detection in Bridge Structure Using Vibration Data under Random Travelling Vehicle Loads

Damage detection method for structures based on the relative variation of wavelet total energy

A Novel Mode Sharp-Based Damage Detection Method of Large-Span Bridges

Bridge Damage Identification Using Vehicle Bump Based on Additional Virtual Masses

Using Two Sensors for Damage Detection of Bridge Based on Transfer Entropy of Vehicle-bridge Information

Damage Detection of Continuous Beam Bridge Based on Maximum Successful Approximation Approach of Wavelet Coefficients of Vehicle Response

Damage Detection by Mode Shape Squares Extracted from A Passing Vehicle

THE TAP-SCAN DAMAGE DETECTION METHOD FOR BEAM STRUCTURES

Review of Vibration-Based Damage Detection and Condition Assessment of Bridge Structures Using Structural Health Monitoring

Drive-by bridge damage detection using Mel-frequency cepstral coefficients and support vector machine