Abstract:Phase change materials are used in passive solar house construction with light steel structure walls, which can overcome the problems of weak heat storage capacity and poor utilization of solar heat and effectively solve the thermal defects of light steel structure walls. Based on this, on the basis of preliminary experimental research, this study further carried out theoretical analysis and simulation research on the thermal performance of a light steel structure passive solar house (Trombe form) with PCM walls. Through the heat balance analysis of heat transfer in the heat collecting partition wall, the theoretical calculation formula of the phase change temperature of the PCM was obtained, and it verified theoretically that the phase change temperature value should be 1–3 °C higher than the target indoor air temperature. The evaluation index “accumulated daily indoor temperature offset value” was proposed for evaluating the effect of phase change materials on the indoor temperature of the passive solar house, and “EnergyPlus” software was used to study the influence of the phase change temperature, the amount of material, and the thickness of the insulation layer on the indoor air temperature in a natural day. The results showed that there was a coupling relationship among the performance and between of the thickness of the PCM layer and the phase change temperature. Under typical diurnal climate conditions in the northern Tibetan Plateau of China, the optimal combination of the phase change temperature and the layer thickness was 17 °C and 15 mm, respectively. Especially at a certain temperature, excessive increases in the thickness of the phase transition layer could not improve the indoor thermal environment. For this transition temperature, there exists an optimal transition layer thickness. For a Trombe solar house, the thickness of the insulation layer has an independent impact on indoor temperature compared to other factors, which has an economic value, such as 50 mm in this case. In general, this paper studied the relationship between several important parameters of the phase change wall of a solar house by using numerical simulation methods and quantitatively calculated the optimal parameters under typical meteorological conditions, thus providing a feasible simulation design method for similar engineering applications.

Thermal Performance Research on a Novel Coupled Heating System Combined Solar Air Heater with Ventilation PCM Wall

Numerical Simulation on the Thermal Performance of a PCM-containing Ventilation System with a Continuous Change in Inlet Air Temperature

Performance analysis of a novel hybrid CdTe-PCM multi-layer ventilated window system for building application: An experimental and numerical study

Numerical simulations on the thermal performance of ventilated walls with passive solar heating and latent heat storage in winter

Research on Heat Transfer Performance of Passive Solar Collector-Storage Wall System with Phase Change Materials

Numerical study and experimental validation of a multi-functional dual-air-channel solar wall system with PCM

Improving thermal performance of a passive ventilation and cooling system by integrating a phase-change material: Dynamic characteristics and parametric examinations

Experimental Study on Phase Change Material with Solar Heater System for Building Heating

Performance Evaluation of a PCM-embedded Wall Integrated with a Nocturnal Sky Radiator

Experimental Study on the Performance of a Solar Photovoltaic/thermal System Combined with Phase Change Material

A hybrid photovoltaic and water/air based thermal(PVT) solar energy collector with integrated PCM for building application

Preparation and Application of Paraffin/Expanded Graphite-Based Phase Change Material Floor for Solar-Heat Pump Combined Radiant Heating Systems

Heating Performance of PCM Radiant Floor Coupled with Horizontal Ground Source Heat Pump for Single-Family House in Cold Zones

Numerical Study on the Thermal Performance of Phase Change Materials Wall by Radiative Cooling

A hybrid PV thermal (water or air) wall system integrated with double air channel and phase change material: A continuous full-day seasonal experimental research

Experimental study on heat transfer and storage of a heating system coupled with solar flat heat pipe and phase change material unit

Experimental Study of Underfloor Air Supply System with Air Solar Collector and Shape-Stabilized PCM

Experimental study on the performance of a novel RC-PCM-wall

Investigation on heating performance of an integrated phase change material Trombe wall based on state space method

Investigation on Designed Fins-Enhanced Phase Change Materials System for Thermal Management of a Novel Building Integrated Concentrating PV

Thermal Performance Optimization Simulation Study of a Passive Solar House with a Light Steel Structure and Phase Change Walls