Kinetostatics for Variable Cross-Section Continuum Manipulators
Han Yuan,Zuan Li,Wenfu Xu
DOI: https://doi.org/10.1109/icra48506.2021.9561795
2021-01-01
Abstract:Continuum manipulators have shown a wide range of applications due to their inherent compliance and dexterity. At present, the cross-sectional dimension of these manipulators is often kept constant, which facilitates the design, fabrication and modeling processes. The famous piecewise-constant-curvature (PCC) assumption is widely used in the kinematics and motion control. By contrast, most natural creatures that have continuum structures usually exhibit variable cross sections, such as the elephant trunk and the octopus tentacle. Inspired by these creatures, variable cross-section continuum manipulators have been proposed in literature. For variable cross-section, the PCC assumption is no longer valid. In fact, the manipulator's kinematics and statics are coupled, which should be considered and solved together. This paper establishes the general kinetostatic model of variable cross-section continuum manipulators, and performs experimental validations under various actuating and loading situations. Results showed that the proposed model has satisfactory accuracy in predicting the manipulator profile under various actuating and loading situations. The average root-mean-square error of the proposed model was 1.67 mm, and even the maximum error did not exceed 2.6 mm, according to all the 51 groups of tests on three 100 mm long prototypes. Furthermore, results also indicated that Type-1 manipulator (only varying the spacer dimension) has larger deflections and tends to be "softer" than Type-2 manipulator (only varying the backbone cross-sectional area). Results of this paper could be helpful for the design and analysis of variable cross-section continuum manipulators.