Abstract:Continuum manipulators have infinite degrees of freedom and high flexibility, making it challenging for accurate modeling and control. Some common modeling methods include mechanical modeling strategy, neural network strategy, constant curvature assumption, etc. However, the inverse kinematics of the mechanical modeling strategy is difficult to obtain while a strategy using neural networks may not converge in some applications. For algorithm implementation, the constant curvature assumption is used as the basis to design the controller. When the driving wire is tight, the linear controller under constant curvature assumption works well in manipulator position control. However, this assumption of linearity between the deformation angle and the driving input value breaks upon repeated use of the driving wires which get inevitably lengthened. This degrades the accuracy of the controller. In this work, the Koopman theory is used to identify the nonlinear model of the continuum manipulator. Under the linearized model, the control input is obtained through model predictive control (MPC). As the lifted function can affect the effectiveness of the Koopman operator-based MPC (K-MPC), a novel design method of the lifted function through the Legendre polynomial is proposed. To attain higher control efficiency and computational accuracy, we use a selective control scheme according to the state of the driving wires. When the driving wire is tight, the linear controller is employed; otherwise, the K-MPC is adopted. Finally, a set of static and dynamic experiments have been conducted using an experimental prototype. The results demonstrate high effectiveness and good performance of the selective control scheme.

Analysis and validation of a planar parallel continuum manipulator with variable Cartesian stiffness

Stiffness analysis of overconstrained parallel manipulators

Adaptive robust posture control of a parallel manipulator driven by pneumatic muscles

Adaptive Robust Posture Control of A Pneumatic Muscles Driven Parallel Manipulator with Redundancy

A Continuum Manipulator with Closed-form Inverse Kinematics and Independently Tunable Stiffness

A continuum manipulator for continuously variable stiffness and its stiffness control formulation

Stiffness Analysis of Parallel Manipulators with Preloaded Passive Joints

Stiffness Modeling Approach for a 3-DOF Parallel Manipulator with Consideration of Nonlinear Joint Stiffness

A Novel Flexure-Based 3-DOF Micro-Parallel Manipulator with a Gripper for Micro/nano Manipulation

A Modular, Tendon Driven Variable Stiffness Manipulator with Internal Routing for Improved Stability and Increased Payload Capacity

Design, Modeling and Validation of a Tendon-Driven Soft Continuum Robot for Planar Motion Based on Variable Stiffness Structures

Dexterity and Stiffness Analysis of a Three-Degree-of-freedom Planar Parallel Manipulator with Actuation Redundancy

Controlling Tendons to Modulate Stiffness of a Planar-to-Spatial Tendon-Driven Continuum Manipulator Under External Uncertain Forces

Stiffness modelling of parallelogram-based parallel manipulators

Continuum Manipulator with Redundant Backbones and Constrained Bending Curvature for Continuously Variable Stiffness.

Stiffness modeling of n(3RRlS) reconfigurable series-parallel manipulators by combining virtual joint method and matrix structural analysis

Nonlinear Effects in Stiffness Modeling of Robotic Manipulators

Full Forward Kinematics of Lower-Mobility Planar Parallel Continuum Robots

Robust Position Control of a Continuum Manipulator Based on Selective Approach and Koopman Operator

Stiffness and Natural Frequency of a 3-DOF Parallel Manipulator with Consideration of Additional Leg Candidates

Kinematic and Dynamic Analysis of a New Cylindrical 3-DOF Parallel Manipulator