Abstract:It has been reported that applying a certain external anodic potential over un-doped (alpha-Fe2O3) and Ti-doped alpha-Fe2O3 (Ti-Fe2O3) electrodes can improve the photocurrent or the photoelectrochemical oxidation rate of water. However, it is assumed in the literature that the potential drops completely across the side of the solid semiconductor (band edge pinning), and the influence of the potential on the interfacial charge-transfer rate constant is rarely reported. In this article, the impact of the applied potential on the interfacial charge-transfer rate constant during photoelectrochemical oxidation of water over the two electrodes was investigated by electrochemical impedance spectroscopy. The results showed that by increasing the applied anodic potential, the interfacial charge-transfer rate constants for both electrodes were increased. The smaller increase in the magnitude of the rate constant than determined by theory indicates that not all of the applied potential drops across the Helmholtz layer, but takes place in both the space charge and Helmholtz layers simultaneously (Fermi level pinning). The results of the surface-state capacitance measurements suggested that the photo-generated charge can be accumulated in the surface states, resulting in the re-distribution of the potential at the interface and an improvement in the rate constant. Under the same applied potential, the higher the light intensity is, the more the photogenerated holes accumulated in the surface states. This causes an increase in the potential drop across the Helmholtz layer and consequently increases the charge-transfer rate constant. Compared with the alpha-Fe2O3, the improvement of the charge-transfer rate constant by the anodic potential is more obvious.

Quantitative Determination the Role of the Intrabandgap States in Water Photooxidation over Hematite Electrodes.

Reaction kinetics and interplay of two different surface states on hematite photoanodes for water oxidation

Unconventional Rate Law of Water Photooxidation at TiO2 Electrodes.

Identifying Water Oxidation Mechanisms at Pure and Titanium‐Doped Hematite‐Based Photoanodes with Spectroelectrochemistry

Identifying the Spectroelectrochemical Characteristics of Hematite Photoanodes for Water Oxidation

Kinetic Difference in Water Photooxidation Between TiO2 and WO3 Electrodes by Rate Law Analysis

Determining the Transformation Kinetics of Water Oxidation Intermediates on Hematite Photoanode

Influence Of The Potential On The Charge-Transfer Rate Constant Of Photooxidation Of Water Over Alpha-Fe2o3 And Ti-Doped Alpha-Fe2o3

Photoelectrocatalytic Water Splitting by Conformal Copper‐Oxide on Hematite Nanostructures: Dependence on Surface‐States

Observation and Alteration of Surface States of Hematite Photoelectrodes

Comment on "On the origin of multihole oxygen evolution in haematite photoanodes"

Monitoring Interfacial Electric Fields at a Hematite Electrode During Water Oxidation

Understanding the enhanced photoelectrochemical water oxidation over Ti-doped α-Fe 2 O 3 electrodes by electrochemical reduction pretreatment.

Enhanced Photoelectrochemical Oxidation Of Water Over Undoped And Ti-Doped Alpha-Fe2o3 Electrodes By Electrochemical Reduction Pretreatment

Multihole Water Oxidation Catalysis on Haematite Photoanodes Revealed by Operando Spectroelectrochemistry and DFT

Unconventional Rate Law of Water Photooxidation at TiO 2 Electrodes

Enhanced Photoelectrochemical Oxidation of Water over Ti-Doped Α-Fe2o3 Electrodes by Surface Electrodeposition InOOH

Effect of oxygen concentration and distribution on holes transfer and photoelectrocatalytic properties in hematite

Rate Law Analysis of Water Oxidation on a Hematite Surface

Bridging surface states and current–potential response over hematite-based photoelectrochemical water oxidation

Covalent Fixation of Surface Oxygen Atoms on Hematite Photoanode for Enhanced Water Oxidation